Viewing all customer Discussions for:

Other

Assistance finding this part?

Hi.. thank you so much for this great video! I need to replace eight crank arms on my 30 year old windows in my 1964 house. I watched people do it before and it looks so difficult but with your video video being so clear and precise, it doesn't look difficult difficult at all so I'm so grateful that ... (cont.)

I have been unable to identify and source replacement rollers as shown in the attached photograph. Can you help, please?

Bottom of upper window where the two windows meet. Hard plastic is 1" wide, front by bulb is 5/8" back is 5/32. Bulb is 1/4. Windows were is pre fab house built in 2002.

Hi there, i need about 6 of the pins like in the picture in beige or white. I've seen them before but cannot locate them on the website. Thanks for any help. Danny, the screen guys.

I'm looking to replace a right hand tilt latch for a milco window.

double casement window. Right side functions, left side broken 25 5/8"x 42 7/8" (inside of window dimensions) We ordered some parts earlier, but they were not the correct parts.

LOOKING FOR THIS ROLLER OFF OF A IRVINE DOOR I AM AN RV DEALER (MOUNT COMFORT RV) NEAR INDIANAPOLIS. I WAS GIVEN YOUR COMPANY AS A POSSIBILITY AFTER SEVERAL CALLS. THANKS, FOR ANY HELP BERNIE MOUNT COMFORT RV

Need to order replacement wheels for the exterior glass patio doors

Looking to get a replacement for this piece. 13.5' arm from center to end. Has a made date of 08162006. 07:30

14 7/8, stamp 1420 can't read the trade mark but next to it it says KC.

Needing 2 (left and right) balancers, and 2 (left and right) sash pivots. Removed what I thought was the sash pivot screw and cannot remove the pivot. The pivot shoe seems wider than the channel? Appreciate any help in advance!! Mike

We want to replace these with folding crank arms. 2 please

Hi, Have rear patio sliding door - would like to have a lock with key for emergency use only. Screw holes are 6 9/16" apart. Door thickness as per photo Do you have such a device? Thanks, Graham

I have pre 1995 pella wooden casement window which i have already replaced the original pull down screen with a newer style rolscreen about 10 years ago. I am in need of about 5 of these guides which go inside the screen guides. See photo below. Thanks, Bob

I need the attached 2 5/8" long x 11/16" Wide

Hello, I am trying to identify my roller for my sliding glass door and get a replacement. I submitted the form in identify a part and said it went to spam so I am reaching out to see if there is a way I?ll be able to get an answer. Thank you so much for the help. Let me know if another angle might ... (cont.)

I need a 110 degree hinge for frameless cabinet. The diameter of the hole in the back of the door that the hinge sits in is 1" The distance between the edge of the door and the beginning of the hole is 3/16". The screw hole spacing on the back of the door, center to center, is 1.5". The hinge I ha ... (cont.)

Need to replace Pella Proline Casement handle hardware, 7 of them

Hi! We had our window repaired and during the process found out most of our tilt latches in the house were broken. My husband just went to install the new ones and realized they were too small and there s these divets on the size which doesn't allow them to slide into the groove in the window. Pleas ... (cont.)