Viewing all customer Discussions for:

Weatherization

Alenco window seal. Upper seal is approx 3/8" and lower solid core is approx 3/32" which fits in a slot to hold the seal in place.

This kerf mount leaf seal has broken down, and is missing the outer flap ( approx. 1/2 ")

Looking for the strip that goes down the side opposite the handle. The right side of the screen facing the door from outside. It is about 76 5/8" long.

Window seals

Hi, Looking for a bottom door sweep triple spline for my screen door. It's .75" wide, .5" high and 35" long. It slides into the bottom "u" shaped cover that goes on to the bottom of the door. Thanks! David

Do know where I can find replacement weatherstripping for a door threshold to match this profile? 7/16" height 3/8" width -John

Semco swinging patio door threshold weatherstripping. For was installed in 1994-1995.

I have a Simonton Casement Window, dimension 1 series 1996. 36x34, that needs the weather strips replaced. There is a right and left crank out window. The round foam measures 7/16" and the flat measures 1/4". What weather strip do I need?

What would you recommend as a replacement for the weatherstrip for the window bottom of my 19 year old home?

Gos on bottom of my double hung window

Foam filled strip on certainteed window appears to snap in

Suggestions?

Hi - I am looking for this window seal. I have not been able to locate it anywhere on the internet.

I am trying to find a weatherstripping to replace the rotted vinyl Kerf mounted T slot V seal. If not the same product then suggest a replacement.

Hi Sliding windows around 1965 need weather strip.

Hi, I'm looking for a weatherstripping that, when the window is closed, is attached to the movable part of the window. When the window is closed it sits between the movable part of the window and the fixed window frame, and is only visible when the window is open. It looks to be made of felt, with a ... (cont.)

Looking for weatherstripping to work with 80's vintage Truth casement windows. The width appears to be about 5/16" The angle base height that fits into the track is about 3/16".

All of the seals are falling apart and I can't seem to find one that's intact that I can remove And show you. The interior seals seem to be ok. It's the ones on the windows that are really bad. They appear to be some sort of leaf seal. Numbers on window 00311510444616 CG - 3 4 -11 LOE ... (cont.)

Hello, I've attached a photo of a door I'm trying to repair. The end/edge of the door is a "cap" that is attached with screws and has two felt strips running the full height of the door. Do you think I can replace the felt strips separately or will I have to buy a piece that's the "cap" with the fe ... (cont.)

Felt strip. Looks narrower than anything I see on your site Slot appears to be 0.25"