Viewing all customer Discussions for:

Weatherization

I have some Traco sliding windows and need some felt weatherstripping. The plastic base is 1/4 inches and the pile is 7/16. Hope this is enough info for you.

Rubber on weather strip at bottom of door is frayed. Piece holding it has two holes on inside to screw it down. It's a herculite from PPG. It is a metal piece and not plastic like the ones at Home Depot. Where can I get a replacement piece

Need replacement weather stripping for commercial door.

I need replacement weatherstriping for 2 casement windows

I am looking to replace the weather stripping on my Crestline windows that were manufactured in 1994, having trouble finding the exact weather stripping needed. Can you assist? Jeff

Looking to replace this unique stripping. Looks like your product 58-055 may work but not exactly. Please advise.

trying to find this felt on the inside of a door next to the frame

I'm looking to reseal most of the windows in my house using wool pile. I ordered a test roll to make sure that I had the right size. If I place an order for multiple increments of 25 ft, will they be separate, or will it be in a continuous roll? Alternatively, is it recommend to only use a single p ... (cont.)

Can you help with finding a replacement seal?

Looking for replacement weatherstripping, either same as original or aftermarket item if it improves on the original. Channel on the astragal is .45cm wide that the "foot" goes into. Original metal doors were manufactured by Stanley, house build in 1989. Original weatherstripping is rubber materi ... (cont.)

Hi, I have a 1997 fiberglass Peachtree 6' sliding door. I'm trying to replace all the weather stripping on the operational door. Top, door lock side, the strip in between the two doors and the bottom (a track with insulation in it that runs the entire length (6'). Any help would be appreciated!! Tha ... (cont.)

These pictures are the weatherstrip on a 1990 wooden door. The bubble side is crushed when the door is fully closed (the bubble is on the left in the pix) and the flexible lip is on the right in the pix. It has on the backside a small lip that fits into a groove cut into the door frame. Can you ... (cont.)

This weather stripping is from Jeld Wen 5 Panel Bow Window (3 fixed panels, 2 cranks). Assuming this window to be around circa 1991 as that is build date of the home and assuming original equipment. No part numbers available. Window Measures 64 inches high and 22.5 inches wide. Composition of wi ... (cont.)

i am looking for these seals...

I have CertainTeed windows that were installed 1994 or about that time frame. The current weatherstripping is 3/16 x 3/16 but the pile isn't attached in the center - it is attached to one side. Will the pile weatherstripping that is attached in the center work?

Is this weatherstripping available to you? Thanks Cameron

We have a wood eight foot Marvin sliding door. All weather strips are gone, tends to allow bugs to enter as they please. Any suggestions? Thank you in advance

Would you have Bottom replacement window weather stripping for KAS-KEL Saratoga 4000 series see pictures I haven't taken any measurements just yet. Need about 26 feet I believe, hope you can help Thanks Joe

This is from an older door (35-40 years), wood interior, metal exterior. I need to replace the hinge side jamb weatherstripping.

Hello, I need replacement weather-stripping for 1997 Hurd clad casement window operating sashes. The color is tan. Bulb appears to be 9/32" tall with flat solid/Rigid base which is 1/4" wide with a centered 1/4" deep kerf piece, with a single kerf barb. A Hurd diagram drawing of what I think is ... (cont.)