Viewing all customer Discussions for:

Weatherization

Hello, The attached pictures are of the weather stripping between our french doors. There is no manufacturer identified on the doors. Install was in 1983. Solid wood doors. The weather strip removed from the door has a 5/16" base and a 1/2" "sealing edge". I don't see anything like this in your cata ... (cont.)

I need new weather stripping for my Simonton single hung windows

Hi guys, Hoping to identify my weather stripping.

Lookin to replace window weather stripping(22 windows), would appreciate your help in identifying the model and replacement parts.

good afternoon, Pictures W1, W2 and W3 are for the same window the issue is that the rubber part that goes around the window is broken so even with the window closed it feel like the window is open for all the cold air that comes in. On w4 and w5 pictures I would like to replace the brush pile ... (cont.)

I am in need of glazing for Weather Shield windows. Do you have something that is compatible with theirs? I ahve attached a pituture for you. thank you, Jim

Hi, We're looking for replacement for the (insertible) weatherstripping to our 2002 Cresline Casement Windows. Attaching 3 photos of the current weatherstripping for reference. Thanks. Best regards -

I am looking for this vinyl the measurments are 5/16" (t-wide) by 7/16" high.

I want to replace the old window weather strip on the screen and bottom sash. I didn't find similar parts on the website. My double hung (tilt) window was installed 2001/8/28. The window tag shows Tee Cee's Home Improvement and has green logo labeled in the lock as "crystal". Any helps on strip like ... (cont.)

I would like to find the replacement part for this weather strip. I have many windows! Can you please help me identify a replacement? thank you

This weather strip slides into a small U shaped groove on the bottom of the sliding pocket door. The plastic top is only about an 1/8" square with about a 1/2" of hair like on the bottom to keep out the weather.

I need weatherstripping for this door. The door door was installed in 1978.

This PGT door sweep is 1 3/8" wide and 1/4" is the upper sides that slide into the under side of door frame. Door is from 2005. When inserted into bottom of door it's not flat makes its like a bulb bottom.

Hi, I’m looking for a replacement glazing beads for my window. I’m attaching here some photos. The dimensions are like 11/16 and 5/16 inches. I appreciate letting me if it is available Thank you,

Hi, I am trying to identify this bulb weatherstripping. I am hoping that you might be able to match it. Measurements are:Bulb width is 5/16".Bulb height is 4/16". Height of base is 1/8". Width of base is 4/16 to 5/16". Thank you for any help you can offer Anthony

Looking for replacement weather stripping for windows

I had my window replaced and this is what the technician put in and used a sticky tape to adhere it in place. We live in Florida so it unstuck and got caught between the windows causing my window to not open or close.

Hello, The fin seal feels like a woven fabric, not a plastic strip, and it has two fins. Is this something you carry?

I have exterior doors that need weatherstripping replaced. They measure 3/8 pile and 3/8 width.

Hello, I have the description from the windows installation instructions (Wincore Windows) - but still wanted to make sure I selected the correct one and wanted to get a taller pile to help more with noise and a draft, but would be the same width. Thank you!WEATHERSTRIP ULTRA FAB .270 PILE - 270 -18 ... (cont.)