Viewing all customer Discussions for:

Weatherization

The door was installed in 2019. Manufacturer is Taylor. Dore is 1-3/4 inches deep and 33-11/16 inches wide. Does Swisco sell a bottom door sweep to fit this door?

I have mid 1980s vintage Andersen Perma Shield casement window. Can you tell me which, if any. of your bulb seals would fit these windows?

Hi, I need to replace the weatherstripping on our windows. The glass says Cardinal IG. I think the size is .35" x .35"

Hello. I am also looking to replace weatherstripping on some double hung M&W windows -- which were also installed in the late 1980s. Below are pictures. Any recommendations for replacement weatherstripping? Thank you.

Hello -- I am looking to replace weatherstripping on late 1980s M&W casement windows. Below are pictures of the weatherstripping at the bottom/top of the sash and weatherstripping on the side of the sash. They appear to be the same design but slightly different dimensions. Any recommendations for re ... (cont.)

As you can see previous owners put one on top of another the bottom one seems to be a sticky tape piece any ideas how to replace paella windows thermastar 15 years old double hung

This is the weatherstripping for the exterior doors I'm needing to replace.

Hello, I have the following foam filled bubble seal in the pictures and dimensions provided. Please help to find an equivalent replacement for this. Regards, Handyman from Illinois

No markings on the weatherstip. It's about 1/2" around and the top slide part is 3/16". Do you have something like this?

Can you identify the correct seal?

Need 5 of these for 5 different windows.

Hello! I need some help to replace this weatherstripping. I'm having a hard time choosing from what is listed on your website, can you assist? Thank you!

The weatherstrip slides into the top of the screen and flap extends toward the sash (mostly gone on the pictured oneJ). I didn't really see anything like this on your site. Unfortunately I don't have window mfg. If nothing like this, maybe I should just use a felt strip?

Closest I found was 55-172 but even that is a bit too large.

I am searching for weatherstrip for Atrium French door. Attached is a profile picture of the existing weather strip and the ID tag on the door. Richard

I am looking for the weatherstripping to cover the interior-side wooden bottom of these weathershield double hung windows. One pic shows with the piece and one shows without. Thanks.

pella door serial number 4395 we need the rubber sealer for the right hand door which remains closed most of the time.

Base is 1/8" wide and is plastic. The pile is 3/8" high

I have a Stanley double front door that is probably over 30 years old. The weatherstrip on the door that does not normally open is old and cracked. I can't remove the weatherstrip because I am still not sure how it is attached. I am sending 3 photos to help you identify the weatherstrip.Thank you,Da ... (cont.)

This is weather stripping from original, late 1950s panel windows. The rubber part seems like it's 3/16 by 3/16. I am assuming the "fuzzy" stuff is missing?