Viewing all customer Discussions for:

39-102 T Handle, 11/32"

Looking to replace 2 left and 2 right crank out operators on casement windows.

Milgard #HL0145BZ fold down, butterfly or drapery crank for a casement window

I would like to replace the remainder of my crank handles with T cranks so I can put my three new shades down. The number on the original cranks are 40085. The t-cranks shown, are the same spine size as 40085 and I have them on five other windows. I just don't know the manufacturer and spline size. ... (cont.)

The white crank says Ttuth inside. The crank hits my mini blind. I want to replace with a T crank. The bigger T crank i purchased is 3/8" and is too big.

We need 6 of these knobs. Not sure what to measure. Hopefully you know which ones we need. They are on BiltBest windows. Thanks

Good morning, We are looking to replace window cranks on all the Weathershield windows at our project - the client added shades that are interfering with the cranks, and we are trying to find something that would be flatter to replace the old cranks. Here are the measurements once the crank is remov ... (cont.)

I need to switch out my Crestline crank handle to a tee handle. I am putting in shutters. I bought a universal replacent set at Home Depot. The tee handle has a plastic insert to go over the crank. The Crestline uses a oval point set screw vs. the home depot cup pt. I dont think it will work. Will ... (cont.)

I am looking to replace my cranks with tees am putting up minni blinds.my cranks are slip on, most I see have set screws are they interchangeable?or can you buy tee slip ons thanks steve

Looking for new folding window crank (or T handle?) and cover in white (different color than it is currently) so that I can close my blinds all the way? Casement operator is Truth Entry Gard. Gear bore is 3/8".

Good afternoon. I have Wright Windows, aluminum, and need two "T" cranks. Can you tell me if I need to fit an 11/32" or 3/8" spline. Thanks Dave

Hi. Please let me know if I can get 3 of these removable cranks.

I currently have handle Code: 39-114L in use on my casement windows and want something a bit more compact so blinds can lower. Is 39-205 able to be swapped out to get a more compact result or would more modification be needed by swapping out the assembly?

Hi, I believe these were on our Scherer Brothers Windows here in Minnesota. It just says Truth Hardware on it with no number. These are plastic and cover the mechanism that opens and closes the windows. Thanks for any help you can give me.

ok

I'm looking for t handles and folding cranks for egress and non egress casements.

Cranks and levers to open up casement windows. One is shaped like a bow tie, the other is like a crank.

Patent # 45056014521993Cover #45015Base#45013Gear broken. What replacement would you recommend that will fit?BArbara

Looking for replacement for this operator, has 7D100P marked on the one arm and truth marked on the other.

I have one right hand and one left hand casement windows with the same problem and need to replace the operator(s). Please help me determine the replacement part numbers and prices.The straight arm is approximately 9 inches longRichard

I believe my casement windows are Pozzi Windows. I need 2 white operator covers and 2 white T cranks. The number of teeth on the operator is 12 and there is a notch. The number on the crank handle is 45054. Note: T cranks are going to replace the arm cranks.