Viewing all customer Discussions for:

39-107 Truth Hardware Operator Cover

The cylinder is not engaging so the crank doesn't open the window. The arms are working. The Caradco cover needs replacement too.

Hello, I need to replace this part plus the crank handle for several windows. please advice.

Replacement arm needed.

Swisco previously helped me with another casement window part with my order# https://www.swisco.com/page-ords?Order_ID=2203953. That window is now working perfectly. The current problem window needs the operator replaced. I haven't been able to open it but I know that it is another "Truth" window ... (cont.)

I'm not familiar with windows. Is this apparatus the only thing that holds the window on the bottom? When remove it I assume I need the window closed and locked - correct?

Left and right I need the complete assembly

I have an older crestline installed window. The crank is no longer working - can't open or close the window. It has a pin that should go in to line up with the gears so the crank will do it's work but I cannot get that back in to its correct place. I am wondering if I should just try to get a new cr ... (cont.)

Only marks = Made in USAJust need the housing/crank not the window hardware (already installed) (Painters removed and then lost them!)

I have one bar (arm) Truth hinges with the number 40942-A stamped on the bottom hinge. I'm assuming these are no longer being made (they are on 25+ years old Marvin windows). Does the 2 arm- Right Hand (Standard) Casement Window Hinge Assembled 10" replace the old one arm 40942-A. Will I need a ... (cont.)

Which operator do I need? Casement window is 27" wide. Short arm 4 7/16" Left handed. Is it returnable if the repair man to fix broken glass has an operator in stock?

I have Loewen windows that were installed 2001 or so.Screen pins.Awning window cranking mechanism.

Handle gear does not stay engaged when closing windows. Crank stop maybe broken. Looking for 2 replacement screw left and right side.

Hi, Can I replace stem. handle and cover, or comleete mechanism for this RT side casement window?

Hello dear, I have half dozen of these operators above not functioning properly as they keep skiding when being turned, please refer to photos & advise which parts I need to order & how to replace them. thanks.

won't crank out

I have one window that is completely separated from the mechanism on each side of the window that assists the window open and close smoothly. I'd like to replace the components that are on either side of the window. I uploaded a few pics of the parts that were visible. Not sure if there are addition ... (cont.)

I have a two-pane window above my kitchen sink that has a crank mechanism on each window. I would like to replace the two crank mechanisms. I uploaded some pictures.

Crank/gear window handle

long arm is 9"

I measured #20810 at 4 7/16 main arm 9 3/8 large numbers on part R30842. I could reuse the old crank and cover