Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

Request help for replacement crank assembly and locking mechanism for a casement window (Window #2). Photos attached. Very pleased with your help a few weeks ago with Window #1.

Hi,I need to replace the mechanism for a few window cranks for Hurd windows.I'm adding photos of the cranks that need replacing.Thanks,Ela

I have a right and left swing and the crank on right side is stripped and will not pull the window in. I would like to replace cranks on both to fix the stripping issue.

Need a handle like one pictured.

I am looking for the crank handle so I can open window for a Crestline casement window. Crest-o- pane 72-82 was etched in the pane

This is broke

Looking to find the right info to order the awning crank for this Marvin Window which is approximately 17 inch wind by 13 inches tall. The cartridge is shot and I believe that I need to replace the crank. The current and original is a TRUTH item but I can't find any numbers on it. Thank you ... (cont.)

I need to get a replacement dual arm operator. Seems to be K/K manufacturer. The distance between screws is 4 7/16 inches. The small arm is 3 15/16 inches. The large arm is about 10 inches. The small arm has a number 20810. Can you advise which replacement part to get. Thanks Albert ... (cont.)

The only part number that I can discern says 30806. There are some patent numbers (US 4505601) on it and says Made in USA.

Please let me know what part to order. I will then order five each. Thanks

Assisted living facility in Buffalo ny, in search of these window encasemebt arms. Possibly a Anderson window

Hi, I need help identifying this crank assembly for a client. Attached are pictures of the (2) part numbers that appear on it.

The 3 crank handles on our window are breaking off at the base (see photo right hand side)I need to identify and order replacement crank assemblies for Series #6100 Bow window purchased around April 2003, purchased from Home Depot, Allentown, PA. Also, I need instructions for replacing cranks. Thank ... (cont.)

I have some issues with some windows from Fibertec. For some the handle is spinning but the window does not open. Do I have to replace the whole mechanism or just the handle. I am enclosing pictures of the outside of the mechanism and inside. The distance between the screws is 5". The tie bar is tr ... (cont.)

Do you have an operator like 39-031 with a 3 13/16" link arm?

I believe this window operator is an Anderson. I believe these windows are original and our house was built in 1967,however I don't see any markings or numbers on anything. I did measure the arm and it's approximately 9in. I would greatly appreciate any help that I could get identifying the window o ... (cont.)

Please check attached photo and advise if you do have it

I'm looking for four of the attached pictures 2 are left hand and 2 are right hand . There is a Patton number on the back that reads 6.247.270 . I was told the item was discontinued.

The gear and shaft for the window is broke off from the rest of the assembly. We also need the latch for the window. It is a left side latch on the window and the crank is to the right side of the bottom of the window unit. The windows are from the mid 90"s. Part number on the latch assembly is 3 ... (cont.)

I have these circa 2008 (Milgard?) casement window handles. They stick out quite far and get in the way of the window blinds. Do you know if a folding handle is available? And if so, what might be a good color match? Thanks for your help! Sorry, I meant to put this under the folding spline handle, n ... (cont.)