Viewing all customer Discussions for:

58-045 Gray Pile Weatherseal, 9/32" x 1/4"

I think this is Kolbe door, circa 2001-2002. The seal/gasket is brown. It needs replaced; it is torn and falling off the rail.

I need a new brush strip. Old one has split. Home Depot says those are a window vendor thing.

Hello! I am looking to replacing the weather felt on my 1997 better-bilt windows. attached is a profile of the pile and of the base. looking forward to you response. regards David

How do you determine how much wool pile you need. I have 10 double hung vinyl windows in varying sizes.

It looks like I have 1/4 X 1/4, It has a hard plastic back that slides in a channel. Looks like your pictures but no sticky back. I am going to need 3 25 foot rolls give me est with shipping. Thank you David

This piece is what holds the weather stripping in on the top of our sliding glass doors. We have 2 that are broken so need to know if they are available. I don't see any manufacturer on the window or tracks to know who makes them if available. It is made of hard plastic

I have an aluminum frame door that is missing the pile weather stripping. It looks to me that I can slide a new strip in the channel. It is a 1/4 wide but the inside is maybe an 1/8 bigger on either side. It probably needs to be 1/8 tall

This is the seal next to the bottom rollers along the entire width of the door.

Where the wool pile meets in my windows meets a 90 degree angle, is there a special tool needed to replace the wool pile?

Hello Tim. Thank you for a quick reply. It may be the 58-021, 58-042, 58-045, 58-128 or 58-158. There is a seal in the center that I can see and similar to these models. Do you know what the standard size for these are used on the windows? Thank you, Henry

Hello, I am trying to find the correct replacement wool pile for our windows. I think the correct part number is 58-128. Could you look at the photos and advise if this is the correct part number? Thank you Mike

> Hi Tim, > > Please see pictures below of my aluminum windows/weatherstripping. Hoping you can help me, I just measured the sample and it is 1/4". > > Thanks, > Jackie

Do you carry weatherstrip like this? Our house is a modular, built in 2009, the door is aluminum. The opening of the metal strip is about 1/4". I don't need the metal part, just the rubber weatherstrip. Thank you very much.

I believe it to be 1/4 x 1/4 stripping for the door..... I only saw a stick on option so I figured maybe y'all could point me in the right direction....

I need to order this weather stripping but not sure which one it is. I've attached images based on the directions on your site. Thanks!

Hello - I am replacing the gray wool pile on a 39 year old Peachtree patio door. Images are attached. It looks like the base is 9/32 " wide. The measured height is 1/4 ". Do you think this trim will work. Mine does not have a center fin down the middle. Thanks for the help. Buster ... (cont.)

I have an old aluminum window panel that holds 2 movable glass plates and screen. The aluminum window frame is mounted on the outside of a wood window. I am painting the window frame and need to replace the pile strip that is broken and worn out. I cannot find a replacement at the stores. The pil ... (cont.)

Which of your gray pile weather stripping do I need to satisfy my requirement of decimal dimensions .270 back x .260 pile height? Your fractional dimensions 1/4" could go either way at .230 or .260

I am looking to two types of weatherstripping for my sliding glass door: A wool pile and a bulb seal. I would like to send you samples, and also photos.

What is your equivalent too .270 x .250 wool pile weather stripping with no adhesive backing?