Viewing all customer Discussions for:

70-180 Storm Door Insert Clip

This strip hold a window screen in a screen door. After installing the new window screen, these strips are the length of the screen door (approximately 68") and fit into a grove in the door to secure the screen and fill in the gap between the door and the frame. The color is bronze. The strip is fle ... (cont.)

These strips hold window of larsen storm door in place from inside. Probably 10- 15 yrs old .

Screen clips bought before

Retaining strip for glass and screen. Older storm door. Can't tell the make.

I HAVE A TWO SEARS CROSSBUCK STORM DOORS. FRONT & SIDE OF HOUSE. I NEED TO REPLACE THE RETAINER STRIPS THAT HOLD THE SCREEN OR THE STORM WINDOW IN. THEY ARE BOTH ABOUT 39-40 TALL. FRONT DOOR IS A LITTLE WIDER THAT THE BACK DOOR. CAN YOU SUPPLY 4 STRIPS LIKE PHOTO.?

Storm door window retainer clips

The registration # is 07010290035 2043. Color white. One of four retainers is broken length is about 3 1 inches.

Hello, Here are pics of the screen retainers on my storm door. I don't see any part numbers and don't know the brand. Thanks for your help! -Nathan

Can you get these clips that hold the glass in the door of a Cole Sewell storm door? Thank you!

I need some clips to hold my screen in. I will send you a picture of the ones I have. I hope you can help me.

Need to replace all 4 - 2 long & 2 short- for SCR 38 and 3680 GN. Can you tell me where I can find them? Online? .the strips are green?.the two short ones measure 25 11/16 inches and the two vertical ones measure 62 1/4 inches. .the small side is 1/4 inch and the long side 1/2 inch?.the width appear ... (cont.)

I'm looking for replacement clips for my 26+ yr old full-view storm door.Unable to find a replacement locally. Don't know the name of the door manufacturer. Offset appears to be just under 1/2 inch.

Hi, The screen is 31x74 and 1/8th. The screen is 5/16th thick. I don't know what else you need. I hope this is enough.

The two attached photos show the current issue I have with my screen/storm door. One photo shows the plastic storm door insert clip in place. The other photo shows the rivet nut and thumb screw with the plastic insert clip removed. There are several of these assemblies along each side of the door ... (cont.)

I Have a Storm Door, single big picture window, that swaps beteen a Screen and Glass panel. The retaining hardware, not sure what they look like or are called, seems to be missing. The door was installed an unknown amount of time before we bought is so year is a mystery to me. The only info on the ... (cont.)

I have a very large storm window pane (about 5' x 6') and need to replace several white plastic L-shaped clips on the exterior. The clips are held in by threaded bolts (not sheet metal or "tap" screws). There are no markings or numbers on the clips. I need a minimum of two to replace two broken cli ... (cont.)

it holds a window pane in place. I need 8

Looking for seal that holds the glass in place

I am looking for a source for the clips in photo. Windows made by Florida Extruders International circa 2006. Single hung windows with these clips used to hold the screens against the frame.

Can I purchase the retainer strips for my Century Series ChamberDoor?