Viewing all customer Discussions for:

81-027 Sliding Door Roller Assembly, 1-1/4" Concave BB Wheel

Identify replacement please

Can you help me with the part number to match the transom door roller for the attached pictures?

Looking to identify part number for sliding glass door roller assembly. I believe they are Acorn doors about 40 years old. Wheel is 1 1/8" diameter, height is 1", thickness is 1/2" and length is 2 1/4". Thank you

I want to replace these single rollers on 4 or 5 doors. Therefore, order 10 rollers. Just need to know which roller to order. Do I need new door track covers?Length; 2 5/16"Height; 15/16"Width; 9/16"

Our doors are metal double panel probably 40 years old. The roller assembly may or not be original and the doors are extremely hard to open. Track is ok. Can we just get a replacement roller or maybe just the whole sliding door without total replacement. Rollers don't seem adequate since they only h ... (cont.)

Hello, I have an Acorn sliding door that is in need of some minor repairs. I believe if I can replace my handle and rollers that I can avoid replacing the door altogether. The house was built in 1991. The handle has broken off entirely. Photo is included. The bottom rollers seem to be missing an ... (cont.)

Acorn door wall sliding door. Part measurements 1" x 1 7/8' x 1/2"

This is out of the bottom of a sliding glass door. It is 2 1/4" x 1".

Need help finding this patio roller. Please help find part # and cost. Thank you for your help.

Hello, I need two of these rollers for glass patio doors. I did not get pictures of them installed because didn't find out about you until after I went to Ace Hardware & they helped me remove them.

Wheel diameter: 1.25 inch Assembly dimensions: 5/8 x 1x 2 1/8 no names or numbers

I'm looking for the replacement rollers from a Dorwal patio door.

No identifying markings. Assembly is 5/8 wide, see pics for other measurements.

Hi, this is a single wheel roller. Housing is separate. Marking on wheel = D-719 Please help I can not find this roller. I need 2

Attached is the wheel I'm trying to replace for my sliding glass door. Looks like my wheel diameter is 1 and 1/4"

Please.see pictures (attached) A Therm patio door roller. I will need two of these. Please email me back with what to order. Thanks The housing had the typical screw that passed through a hole to connect to the roller. The door as I remember it had a slot on each side for the center point of ... (cont.)

we have older aluminum patio doors and looking for those rollers

Hi. I am trying to find replacement rollers for my Acorn Glass Sliding door. The door is approx 30 yrs. old. I am sending 3 photos of the part I need to replace. I hope you can help. Thank you.

Handle says I have an Acorn DorWall. I'd like to replace with double rollers if possible. 1-1/4" concave wheelThank you,Glen

Dims as in pictures. Roller minor diameter about 1 inch major diameter about 1 1/2 inch Looks much like 81-001