Viewing all customer Discussions for:

81-033 Sliding Door Roller, 1-1/4" Steel Ball Bearing

Trying to locate replacement parts

Trying to identify the part to replace glass door rollerThe glass door is aguardian richburg sliding glass door wheels 1984

I have been unable to locate any manufacturer information on the door or the rollers. Bearings are bad in both rollers This style uses tabs to hold roller assembly in the door frame. It does have top screws just the one bolt on the side below the adjustment screw. The track is worn as well as the f ... (cont.)

Need complete replacement of this part

We're looking for replacement rollers for an older sliding door (1974ish). The only marking we can find is AAMCO

I just need help locating a patio door roller for an older aluminum door

Looking for replacement wheels/rollers. It is a 4 ft wide sliding glass door. The house was built in 1977, door is aluminum.

Steel wheel 1 1//4 inch diameter Housing 1 1/8 tall x 1 3/4 long Overall length 2 1/2"

Part 8314 single roller, 11/16 x 2 inches by 1 1/8 tall

Sorry No hints anywhere on door on who manufacturer is. I looked everywhere.

There is no manufacturing ID on the door.This is for a sliding glass door.

please indicate what part I need! Thank you!!

I found these on a seperate site as F4040 but there's no option to buy. Through a discussion board I found a roller on your site that is said to be a replacement, but they don't look the same. Could you help me identify the right parts? I would need 2 of them.

looking to replace this roller

Need both rollers for an Acorn Sliding Patio Door

I have two large glass sliders with two rollers at the bottom of each door.

Two rollers marked with Product of Del Mar Eng Co Long Beach CA Pat 3,670,357 Both have failed and the door barely moves. Need to locate and purchase two rollers.

The writing on the wheel assembly is Del Mar Eng co PAT 3670357

Hello, I have an Acorn sliding door that is in need of some minor repairs. I believe if I can replace my handle and rollers that I can avoid replacing the door altogether. The house was built in 1991. The handle has broken off entirely. Photo is included. The bottom rollers seem to be missing an ... (cont.)

Looking for this patio door roller - door is probably 30+ years old. The part is stamped with 41781. I looked at your part number 81-004, but I don't think this will work because the adjustment screw on mine is at the top (away from roller), but on 81-004, the adjustment screw is on the bottom. The ... (cont.)