Viewing all customer Discussions for:

81-057 Patio Sliding Glass Door Roller, Pan Am

No marking at all.

PGT Industries doors. No markings on the rollers or doors

I went to Home Depot as well as Lowe's and I couldn't find the item.. is this model still on your catalog???

There are no markings. The last picture shows a Barton Kramer 713 on top. It is slightly larger and will not fit into the door.

I am not sure if this is a thermalume roller. What do you think?

Hello, I need 4 rollers that look like the attached. The upload limit is 5, so I had to send this in several posts. See attached images for shapes and measurements at different angles. I have also included photo of the window sticker on the slid door. The rollers dont have any indication or part ... (cont.)

Hi. I need replacement rollers for my (two) sliding screen doors. The existing rollers are metal with an aluminum casing. The wheel diameter is 1 7/16". The casing is 1 9/16" wide and 1 15/16" tall. I needed to drill out the screws securing them to the frame. I see no markings on the frame(s) or rol ... (cont.)

The Sliding door came from PGT. They manufacture impact windows here in Florida. The sliding doors work fine it is the screen sliding door where are these clay glides have rusted. The ears on both side of it cannot be larger than 3/16". I have found other wheels but the ears or too big they were ... (cont.)

I need help identifying these patio door rollers. I submitted an order with you for item 81-057, but they were slightly off in dimensions... I initiated a return for those items

I'm looking for this PGT patio sliding door roller. Overall dimensions are 1 15/16 x 1 5/8 and 3/4 inches thick at the widest points. It has a 1 1/2 steel wheel. Thanks in advance for any help!

Good afternoon, Can you please tell me what replacement rollers I need to purchase from you for my doors? Attached is a picture of the sticker on the door. Thank you, Gabriela

See subject above

I find no identifying marks on these rollers. As you can see, the housing is aluminum. The outside edge with screw holes was machined to allow a proud tab to remain that secures the rollers in the frame. The doors and trim are oiled bronze in color and are aluminum.

Have older patio door and need to replace rollers. Hope you can help.

I need make sure its correct roller, i lake a homework and match side. Help me

No markings.

The exact size of the of the old roller is shown on the first picture. As you can see by the last 2 pictures, the 81-289 and the old roller is not the same size and the protruding tab is not in the same place.Please let me know the right part number to replace my old rollers and how to return the in ... (cont.)

Hi, I'm trying to find some replacement rollers for my sliding glass doors. They were installed when house was built about 22 years ago. Roller wheel diameter is 1 1/2; roller wheel width with looks to be about 5/16" ; bracket horizontal (length) is about 2"; bracket vertical (height) is about 1 ... (cont.)

There are no marking on this at all. It comes from a slider probably from the 1990s. It is held in place with the ears on each side which set in a slot on the door. Would it be possible to just replace the wheels if the whole thing is unavailable?

I need to change the wheels of a sliding window. The picture enclosed is the exact model required for my sliding window. Do you carry this model? Thank you.