Viewing all customer Discussions for:

81-095 Adjustable Tandem Roller, 1-1/2" Concave

I need the two rollers for my Reliabilt Vinyl Sliding Patio Door. The size is 72 x 80. I also need the track. The track is aluminum 1 5/8 width and the track is on the middle of the aluminum plate.

Mortise lock and metal gliders

Need Help Identifying Replacement Roller - Roller has Stamp "DISCO 2192"

Need two replacements

Not sure which is better to replace entire thing or just the roller pieces

Pretty sure I need Product Code: 81-095. However, the roller appears to be screwed to the bottom door rail from the top of the rail, before the glass was installed. I can see the screw threads pointing downward through the top hole of the roller assembly. So for the most part, they are permanently i ... (cont.)

Trying to determine which ones will work for my door.

Inch and half wheels

My door uses a double metal wheel assembly. The height is 1 1/8", width is 5/8", with a roller diameter of 1 1/2". When installed, there are two access holes from each side of the door. The upper screw holds the roller assembly to the door and the lower is an access hole for the height adjustment of ... (cont.)

I am trying to identify the right part. I suspect that you 81-030 "Acorn" would work fine. I see the roller diameter is different, but I believe the height adjustment would allow compensation for that difference.

I need to purchase some rollers

I attached picture of original tandem roller and the original label that was on vinyl sliding glass door. I hired a handyman to replace the rollers. He installed 1 1/8" tandem rollers & they're not operating properly. Please advise of the correct rollers. I believe it's your 1 1/2" tandem roller ... (cont.)

HI, I need rollers for a sliding glass door. The casing is 1 1\8" high and 3/4 wide. The 2xwheels are metal and the casing has a "V" marking on it. any help would be greatly appreciated. Thanks Corbett

Hello. Doors have two stickers on the back indicating... 1) Guardian Industries, 16CFR 1201 CAT II, Z97.1 1984, and 2) Fleetwood Aluminum Prod. Inc. Doors measure 78-1/4" (H) by 57.0" (W). Wheels -- what's left of them -- measure 1-1/2" diameter by 5/16" width. Any assistance that you can provide ... (cont.)

No marks. 1 1/4" wheels. "High top" wings on top. Similar to CRL D1996 but with 1 1/4" wheels

Please identify

Vinyl framed sliding door. About 20 years old.

I need to replace the sliding door wheel but can not find a part number. It does have a V in the metal

Looking for replacement wheels. Bearings inside rollers appear to be worn and/or damaged.

Need 2 . Need part # to order them