Viewing all customer Discussions for:

10-101 7/8" Round Shower Door Wheel

I have a frame less glass shower door that need replacemnt rollers for. The roller has a 1in o.d, convex or oval profile, has an S626Z bearing and takes a #8 machine screw to mount.

Looking to replace these, our shower doors are old but still in good shape besides these rollers

Original 1972 sliding wardrobe doors on a 5' track. They slide into a narrow place on the inside frame. I have tried to reconfigure with a newer pair of rollers, but it's not really working out. Thank you

I need 8 bearings to replace the broken one in the photo above. The roller is 7/8 inch in dameter, the nylon roller is 1/4 inch thick, The entire bearing is .455 inches thick and the screw I believe is an M4. The screw is .475 inches in total length, .16 inces in diameter and the threaded portion is ... (cont.)

Goodmorning,I am looking for 1" (25mm) rollers for 2/ 9 year old sliding shower doors. I have included pictures below in the attachment. Do you have a similar product? Thank you. I have to take the shower door off the track in order to send you pictures. It is a 2 man job, and I am by myself. ... (cont.)

needs

I am looking for this style of replacement rollers.

23 mm roller (non threaded) with a 4 mm flat headed screw about 12 mm long. Must have about 2-3 mm brass ring sticking out on one side and indentation on other side so flat head screw is flush.

Do you have a roller as in the picture?

No numbers or markings on rollers. Any help is greatly appreciated. Thank you.

Hello. I have patio screen doors from 1963 that need replacement. The part is 1" 3/16th wide Almost 2 inches high including roller. I've included a photo. Any idea what would work? Thank you.

Need replacement shower door roller. Looked everywhere and could not find anything.

Shower door wheel, OD roughly 1". Width roughly 0.250". Precision/quality ball bearing, with installed "nut" on one side (hex size = 0.372") Internal female thread inside nut to accept mounting screw.

Hello, I have a 20 inch drawer slider, that the roller has broken off the part of the slider attached to the cabinet frame. I tried to replace the whole slider, but the drawer portion of the slider is incorporated with the sides of the drawer, so can't be replaced, and did not match the new slider. ... (cont.)

Red these parts. If you don't have the bracket then the rollers/wheels would probably be fine as well

Roller dia 19 mm c 6 mm thick, And 12 mm dia x6mmthick

Need to find replacement rollers. These seem to be worn allowing the drawers to drag. They are part of a Knapp & Vogt slides made in Grand Rapids Mich They are about 7/8 inches

Hi ,I am looking to replace a Stanley Dial closet Roller. I recently tried one from National Hardware (V-795) but it didn't work . The wheel is to close to the track.The ones I am trying to replace have a .125 shoulder. Wheel diameter is.84 .Offset is 7/16. I have attached photos. Both doors had th ... (cont.)

Actually I only need one

The slide in the picture is from a Wood-Mode kitchen cabinet. 22" slide Roller style is round, with is 1/4", diameter is 7/8" ( The worn rollers are ball bearing type) Looks similar to your 10-101 roller?