Viewing all customer Discussions for:

84-016 Screen Door Roller, 1-1/4" Dia Nylon

I am looking to identify the roller attached. I have the screen door name tag attached as well.

Hello,I'm looking for rollers like shown in the photo for my screen door. I've found these similar rollers locally but they are too wide for the slot in the metal frame. I suppose I have a nonstandard metal frame door, it measures 7/16th inch wide outside to outside. The screen door goes with a vi ... (cont.)

This is a roller off of the drive-through screen window Kawneer brand

Photos attached of screen door rollers. No names or model numbers available. Te mechanism uses a gear and drive for adjustment of roller wheel. Able to identify or provide part?

the wheel itself is 1 3/16" in diameter.

One of the tension rollers in my sliding screen door broke. It was a nylon wheel with a nylon axle pin. The axle pin broke. Your 84-016 and 84-104 both have the proper dimensions. Is there any advantage/disadvantage of the metal roller vs the nylon roller? I'm thinking the metal roller will be mor ... (cont.)

This roller has the same dimensions as the 84-016, however the top "spring" is rounded on mine vs. the sharp corner on the 84-016. Would this make a difference? Thank you!

Thanks for your help identifying the rollers i need. I need 2 of them. the lower screen door assembly has a phillips head adjusting screw that I estimate is about 2 inches long. The roller is held between two metal plates that hold the axle nubs tightly but I was able to remove the wheels by gently ... (cont.)

Please advise if you can provide 4 sets of these 2 parts? Total 8 pieces.. The cost and time frame?

Which galvanized corners and metal rollers do you recommend to replace my current ones in the attached pics. Thanks! -D.

Hello, I'm in need of (6) of the below pictured wheel assemblies and replacement 'Fur' for slider. Can you help me?

Need a replacement for a rusted 1 1/4 concave metal for a outside screen door

Hello, looking for a patio screen door corner that is build better than average, even better would be nice, my current corner is 1 5/16" wide by 1/2" thick, and the splines are 3 3/4" long to match the current hole. Wheel assembly needs to be serviceable, don't see a way to search for specific size, ... (cont.)

Hello, I'm looking for the 4 corner brackets and 4 wheels for this door. Thank you,

Can you please tell me what part I need for this door? The roller is white plastic and has chipped.

I'm looking for replacement parts for the Corner piece and wheel. I would prefer metal parts.

I have Jeld-wen screen doors and the leading edge has a gap of about half inch (vertical leading edge between slide door and frame). I can adjust the front most wheel pushing the door up and closing the gap, but not completely. The wheel itself seems to be in good shape, not so sure about corner/ad ... (cont.)

I am looking for a replacement part for my sliding screen patio door. I need the corner part as mine has broken where the wheel attaches at the joint. Was not sure what would be the correct replacement part, in metal.

Could you please identify this roller for me? Have customer that needs them replaced and having hard time finding. Thanks Screen Man

I have a Jeld Wen patio door I purchased in 2009 and the screen door rollers are broken. Jeld Wen tells me they cannot replace the door nor do they have the roller assemblies available. I'm not about to replace a 900.00 door just to get a new screen door. Would you have a roller kit for this? Th ... (cont.)