Viewing all customer Discussions for:

84-091 Screen Door Roller, 1" Nylon Wheel

No idea how old the patio screen door is, no markings/name/numbers stamped on it. Can't find any replacement with the open hook-type.

Hello, I'm looking for the 4 corner brackets and 4 wheels for this door. Thank you,

Do you have anything that will replace this part? Since this is in Hawaii nylon would be better since the metal parts rusted out..

There is a slit in the mount hole.

Can you please tell me what part I need for this door? The roller is white plastic and has chipped.

I need this part is an metallic bracket from a mosquito net aluminum sliding door

Sliding screen door roller

Plastic black piece wheels hook too

I'm looking for replacement parts for the Corner piece and wheel. I would prefer metal parts.

Hi, the sliding screen door manufacture by "Alumco," and says "Aluminite." Thank you, Stu

One of the screen door roller is broken, and we need to order to replace it.

Can you please help us identify this item and if we can get from you Thanks

No names, numbers or markings found - except I think a "1"??

No names #'s or markings

The door say SGD-C20 series 3500. I included it in the photos.

The rollers are metal and get corroded and sticky very easily. Wondering if you have replacements? Ideally ones with plastic rollers. But it is the open-ended clip in that makes it difficult to replace with more generic rollers.

Looking for replacement assemblies.The door is a Pella not sure about the screen.

I need new wheels for my 5 foot slider. It is approximately 20 years old.I am in cleveland, ohio but door is in condo unit at Hidden Valley Resort in Pa.

Hi, Hoping you can match up some parts I need. Corners, wheels and the screen guards ( the little plastic part that snaps into the top of the screen frame) Thanks, Tom

OK my problem is this two the four roller assemblies inside of the door are broken, sadly they are not both on top or bottom they are on opposite corners. I posted the one that has the most assemble on it, my problem is that I am unable to figure out how to remove the balance of the assembly to be ... (cont.)