Viewing all customer Discussions for:

87-020 Sliding Window Roller, 7/16" Flat Edge Wheel

This is from original windows in Larwin Groups' Spacemaker II home. I can't find any info re: company that installed windows. I'm getting home ready to sell--dont want to replace windows but would like to make sure the operate properly open and close and all windows need new rollers. Thanks for any ... (cont.)

Have not been able to find these anywhere.. can you help id and source this roller

I hope these photos help

Hello and thank you in advance for helping with our needed window rollers . Should we send a picture of the existing roller ? We can remove it and take measurements .

Any thoughts on these?? Our windows are 50 years old (townhouse). They are difficult to open since most of the rollers have cracked and broken. Each window has (2) - one on top and one on bottom of slider. Do you need pix of windows??

I need replacement sliding rollers. The dimensions are 1/4 " stem width. 7/16" brass roller. 9/16" collar at the bottom.

I have windows from the 60s I need these glides

I'm looking for replacement roller assemblies for my slider windows. There are 4 on each corner of each slider. The windows are original to my 1978 Arizona home. Thank you for any help you can provide.

1/4" x 1/4". Wheel is 1/2 inch diameter

I'm having trouble identifying this roller. The house was built in 1987 and the windows are original. Any help would be appreciated.

Window glide. Keeps window centered in channel Roller assembly rolls window smoothly.I think they were International Windows out of Union City or Hayward Ca.Era 1970Byron

We need to replace these pieces, window rollers, from windows that are appx. from 1990. Thank you. Chris Roberts

My question iss about your part #87-020. This is the only window roller design that fits my windows, however the original part from my windows (from the 1980

follow up question, please. My home was constructed in 1972. I need replacement rollers for an International sliding window. It looks to me that the 87-020 is what I need-any other suggestions? I already tried a Slide-Co 17474 which worked in the insert (stem) part and the roller was the s ... (cont.)

The house was built in 1973 and has aluminum framed windows. I hope you can see in the photos that I need the roller that fits ( screws in) at the end of the bottom of the frame so the window will slide open smoothly without being metal on metal like it is now. I need 14 pieces ( 7 windows) to mak ... (cont.)

Looking for 20 pieces. I believe these are for international single hung aluminum. They square the sash in the frame. Thanks Jim

I

I would just like to comment on the service I have recieved by staff at Swisco. It has been wonderful. I have not purchased much - just my home needs on my manufactured home, but without your expert staff and inventory it would have been so much more difficult and expensive. I want to thank you a ... (cont.)

I believe that this sliding window roller is what will work but mine as one of the pictures in questions asked has holes in it for placement. Does 87-020 have any holes in it or just need to drilled out Thank you

Can you give me the two dimensions at the end of this piece, opposite of the roller end (87-020)? The old one that I have is about 1/4 x 1/4 inches.