Viewing all customer Discussions for:

88-002 Wood Pull, Hourglass Shaped, 6-5/8"

Hello, I am looking to purchase one door handle and 4 door rollers.

I need to replace the lock in these photos. Here is the text from the sticker on the door: ETL SPONSORED MANUFACTURERS CERTIFIES CONFORMITY TO ANSI/AAMA 101-88 Spec: SGD-R20 Series 3000/3100 Code: 92-2 MST: 12068 (0X0) INDEPENDENT FORCED ENTRY RESISTANT CONFORMS TO ALIDATO 1303,5-76 I would like ... (cont.)

Older sliding aluminum windows with handle and locking device. Locking device does not work to open or close.

Needing to upgrade my doors basic handle to sormthing with handles to make it easier to slide

Hello, I am looking for a replacement handle to fit a NAMI sliding door 4780. I have not taken it off but am including three photos.Thank you,Martin

Bought aftermarket handles to put on a sliding glass door. Could only install on one side as the exterior side of the door does not have screws. Do you carry a mortise lock with screw holes on both sides that I could replace the existing lock with so I could have handles on both sides? Lock panel i ... (cont.)

Hello my sliding door lock/latch broke the hole was built on 1995z. The lot mechanism door handle appears to be your brand. I have attached pictures. Please let me know if you can provide a replacement

Hi, The door at our house no longer locks or slides so I want to update all the hardware to its original form. The previous owner modified the lock on the inside of the door. Looking for lock/latch/rollers Door Information Series: 2000 ANSI/AAMA 101-88 SGD-C35 MST: 12080 Thank you ... (cont.)

I ordered handle #82-030 but it is not the right handle to my door. Can you please look at the photos. How do I return this part that didn't fit my sliding door. Door brand is guardian. Thank you in advance for your help

I need to replace this door lock

Looking to replace this locking mechanism. The latch portion of the lock has snapped and no longer locks the door.

I'm looking for a replacement for this lock. The only problem with others I have tried is that this silver piece is almost an inch long. All other replacements I've tried aren't long enough. The door is just shy of 2" any help would be greatly appreciated.

I need help finding a lock mechanism for this DMS handle.

Hi, I have swisco 82-002 already installed and looking to add a handle on it. can you please let me know, how i can add a handle wihtout cutting to the Door. i am ok to replace the lock but i dont want to cut the door frame.

I need to confirm what I need to replace old sliding glass door inset and if a handle can be added.

Hi I am looking for a handle replacement see pictures. Locking mechanism is ok. Just the handle. Can you suggest something. Thanks Andy

Has the word Nite-Lock on it 6 5/8' screws center to center My best guess to match 82-002 but in chrome 88-002 handle add on

I would like to order a new sliding door handle

Team, I am considering replacing the lock and handle on some doors at a large property and some only the pull handle using existing vintage version of your locking handleset attached. If I used handle and lockset, what size screw would I need to pass through the pull holes and into your replaceme ... (cont.)

I am hoping to find a solution that will provide two handles (inside and out) as my wife has a hard time pulling on the non-handle solutions on the exterior as it take a good amount of finger strength to open the door from outside without a handle. I also want a latch that key locks on the outside, ... (cont.)