Viewing all customer Discussions for:

88-002 Wood Pull, Hourglass Shaped, 6-5/8"

The bottom screw is stripped. So I'm looking for a replacement assembly. Measures 6 and 3/4" from center to center of the two screw holes. 7 and 1/4" height 7/8" wide. model or part # is: SGD-R20-180x96 Mfg code: BB-2

I am looking for a replacement sliding door handle and lock-set to replace the one shown in the attached photographs. The size of the existing lock-set is 7 1/4 inches by 7/8 inches. The center to center measurement between the two screws is 6 5/8 inches. The opening for the lock is 15/16 x 7/8 inch ... (cont.)

I need this patio door handle

We are in need of a pair of replacement brackets shown in the attached photo. It

I am replacing what looks like the 82-002 for three sliders. I see the 88-002 for the interior handle. I want to also have an outside handle on the three sliders. I do not see that?

I am looking to replace the handle and lock on an old sliding glass door. The door does not lock. I've attached photos and measurements. Photo 1 - It is approx. 6 1/2 inches from the top screw to the bottom screw on the handle that opens the door from the inside of the house. Photo 2 - It mea ... (cont.)

Our sliding door is difficult to close from the outside because it only has a flush mount handle. It is a DNS with a screw hole spacing of 6-9/16". Ideally I would just like an inexpensive outside handle. I have pictures but I cannot paste them in your message. Cheers Nick

This lock is broken on my slider and I am trying to identify which part I need...The lever also needs to be replaced. I don't see a piece that accomodates a lever on the site? Please HELP

I need a replacement handle with interior lock for a Kinco sliding door. Can you help? Thanks!