Viewing all customer Discussions for:

89-021D Diecast Keeper, 7/16" Deep

Hi my wife & I recently purchased a home & The previous owner installed a doggy door onto the rear sliding door. They didn't give us the original lock that attaches to the door frame at the wall. The sticker on the wall says Series AV 450 - SGD R20 99X95. Do you know what part we need to get to repl ... (cont.)

Is the depth dimension of your 89-021 the same as the steel version, 89-021D, which is 7/16" ? The reason I'm asking is I need to replace a Weathershield sliding glass door "Recessed Lock Raised Jam Keeper" part # 972496 (This is not the actual part number off the piece, it's a number I got fr ... (cont.)

measures approx 3" long by 1/2" wide, latch position is halfway 1 1/2". circa mid-1908's. Have 2 doors, this one is intact, the other is missing! thanks - can't find it on your "keeper" page Saul

I need to replace the mechanism that's in the photos I've sent. The only markings on the mechanism is "SC". The inside of the handle is 1060-1943. Any assistance would be most appreciated! Thanks! Alan Percival

I have a customer that is missing a door strike on a sliding glass door. I attached pics showing the lockset and a pic showing where the missing strike plate was. I am not sure what strike plate to order. Thanks, Jon

The patio door doesn't lock well because the hole in the frame has rounded out. Do you have something that we can use to solve the problem? Some have suggested replacing the entire door but the glass is fine and so is the rest of the frame. Thanks

The keeper is missing so I can't send you a picture of it. Instead I sent a picture of the handle, an image of the outline of the keeper in the door channel and a picture of the latch. Please let me know ASAP if you can provide the property keeper for our door, Thanks, Michael

My rear door is a slider to the deck and the latch for the lock is missing. No names on the Door. The latch is 4"x5/8". The door is 1 5/8" wide. The latch from the slider only comes out of the door a small distance. The latch must fit within the opening in the slider part of the door to be able t ... (cont.)

I am missing a keeper for my vinyl sliding door. I see that your mortise lock-round face appears to matches what I have. The latch hook of that lock extends 0.237 inches when in the lock position. Which one of your keepers works? The second photo shows the screw hole layout of the missing keeper ... (cont.)

The 82-218 latch appears to be the exact replacement for my sliding glass door , which I have actually located in San Antonio Tx, BUT my latch has a extra escutchion type part that fits around the oval part of the latch and over the monting holes of the latch. These two parts are then assembled tog ... (cont.)