Viewing all customer Discussions for:

91-140 Larson Slide Bolt Set

Attached is a picture of the window latch on my Larson storm door. The other latch has cracked and the tip does not slide out of the door channel when you pull the latch in. I checked the Larson website for "door parts" and they offer closers, door handles, etc basically parts you can get at ... (cont.)

I am missing the right side looking from the inside, that keeps this window locked and not fall out. The picture in windowdoor 1 is of the left side. Hopefully you will have this part. I can also be reached at Mike. Thank you for you assistance.

No markings on the latch or storm window. I wish to find replacement latch as the window, and several others, have either broken springs or rusted springs. Therefore latches only close by manually pushing them closed. Note the spring is held in place with the indent that is circled. ... (cont.)

These tabs are from storm and screen windows installed in the early 1960's. They are on the exterior of 28 double hung windows. Most of them have to be replaced at this time. They are a hard plastic composition with 1 spring per tab. No identifying markings were found on the storms or the window sa ... (cont.)

looking for about 16 of each the rh and lh , or do they come in sets?

Storm Door is a Larson/West Point from Lowes.

I would like to know what type of window replacement latch I need to order for my Larson Storm windows. Your assistance is greatly appreciated. Sincerely,James

I am looking to replace my latches in my storm Larson window. They appear to be made of some sort of cast metal; do you have this replacement part available?

Hello. I am interested in purchasing these locking clip for a number of window screen. Do you carry anything like this. Thanks

I need 2 right window latches for a Larson L203E storm window.

I am looking for a left side slide bolt for a storm window. Do you have anything similar?

Hello, Just got off the phone with one of the reps who asked for some images. Here is what I have. 91-140 is close but not quite the same. If it will work, I'm happy though Looks like 3 ¾" total length here but otherwise seems to match up in measurements. My other concern is that the angle of ... (cont.)

Looking to replace Larson stormdoor window pane latch and springs

The one I purchased is too thick. Spring inserts behind slide, instead of in slide. Seems slide is hallow inside. Left side is in picture but right is broken. Larsen - storm screen patio door I believe is manufacturer but purchased over 10 years. Would like to replace latch or find new storm window ... (cont.)

needto replace them i could not find model #

Please advise on parts needed: Tilt Latches, right and left, sash is approximately 1 3/8" width. Coil Balances for both sides and pivot bars. All for a lower window.

I need this slide bolts left and right handed a set. I need 4 for both windows I measured 3 1/2" by 7/16"

I am looking for replacement part(s) to fit the right side of this storm window, and also the spring is missing on the left side, so I may need to replace both. This window in the storm door was accidentally broken during a job and took it in to have the glass replaced. In the process of having ... (cont.)

I have a Larson storm door in which I am trying to replace the latch on one of the sliding windows. The attached photos are of the good latch on the left side. The right side is what I need to replace. I ordered the 91-140 which matches the latch. When I went to install the spring through, I found i ... (cont.)

Hello, I'm curious if you have any slide bolts to match the ones on my Larson storm windows. I have attached a photo. Thank you for any and all assistance, Maegan