Viewing all customer Discussions for:

95-054 Press Fit Storm Panel Corner

No numbers or markings

One is for the top right. R100. I also need the top left with is called L101

Biu

plastic no mire corner 3/16" thick 1 1/2 X 1 1/2 3/8" wide

Do you guys have this part.

I need several corners like this

I'm looking for window corners. I sent photos of half of the corner I need for the screen. The photo is the measurements of the outside corner to outer edge and thickness of the plastic corner is 1/8x3/8 thickness if you need information please call me

Looking to replace these white plastic spacers that are breaking, do you have anything that would work? They are about 3/16" thick.

I had bought a set of anderson screen frame corners. they were way to big for the screen i have. I could use some help figuring out the size of these. The part i order was 95-169. thank you in advance! I do not know the window manufacturer or the screen manufacturer.

3/16 thick inside screen corner

Can't seem to find a replacement for this window screen frame corner. 1.7 inches in side length. A bit less than 3/16 inches in "height" A bit less than 7/16 inches in "thickness" Attached pictures with markings.

Trying to repair several screens by replacing the plastic inserts in the corners. They are approximately 1.5 inches long on each side, fit into a slot that is 3/8" by 3/16". Pictures attached.

Frame corner piece for mitered screen frame. There is a left and right for the upper part of the screen frame. It has a 1/16"x 1/4 dado cut out at the upper section and has L 100 etched in it R100 for right side.

In search of plastic corner pieces for a mitered window screen frame. Dimensions 3/16" x 3/8" x 1 3/4.

Please help me find these corners thanks

Good afternoon, We are looking for a 3/8-inch Press Fit corner. Pictures are attached which show the prior purchase of 95-054 Press Fit Corner which worked well with the proper frame size for that work order. Our current work order shows the corner previously purchased inserted into ... (cont.)

I am trying to find a replacement corner for some screenwork we are performing at Columbine Ace Hardware in Littleton, CO. Any assistance you may be able to provide will be greatly appreciated. R/ Jim

Hello, Looking for these parts. The pivot corners appear to be from the same brand of storm window. Thanks for the help.

your part # 95-054 is the exact match for the lower conections of the window screen frame. The part I'm looking for is a right and left hand off set corner

I'm looking for an Andersen storm window corner from what I see it's about 5/16 wide and a 16 in thick I sent a picture