Viewing all customer Discussions for:

95-201 Press-fit Corner Key With Guide

Dimensions 1 3/4" x 7/32" x 7/32"

I am looking for zinc die cast corner keys, top tilts, and left and right spring latches for extruded aluminum triple track storm window repair. Attached are photos showing corners of screen. Please let me know if you can supply the correct parts.

the piece is a plastic l shaped piece that is barbdedand holds the screen window in the track of a storm door thank you

Inside corner for a pella screen door window.

We live in older mobile home with storm windows on sunroom. Looking for latch's. I have attached a picture. Thank you so much

I'm looking for replacement bottom latches and top corners (with the pivot points) for these storm windows. Note, there is a small raised point on the outside of the latches that key into the frame

Hello, can I get this same part without the guide? Or what would you recommend similiar?

These are for some older storm windows.

I am looking for some information on where to purchase these same sash tilt corners. They are much smaller than most of the corners we use, and I can not seem to find an outlet for them.

National Nail Midview Self Storing Storm Door ca 1984 ? 1986. Bottom panel of storm door flops inward when door is opened and closed because the top 2 corner keys are broken ? e.g. they are missing the side pegs which should hold the glass panel in the track. Can you help me identify a suitable re ... (cont.)

Hello, I have 7 storm windows with many parts broken. The corner latches are 3 13/16 inches with the point and the notch for fingers is 1/4 inch from end and 3/4 inch long. They are 1/4 inch wide. The end with the point has a tab (see photo of latch in place) that sticks out for 5/32 inch past t ... (cont.)

Broke off of screen windows while removing for cleaning. Is there a replacement part ?thks

I need retainer pins and keepers and springs they measure 3/16"square x 1&5/16" long they are plastic door is probably 25+ years old. The corner keepers in photo are still good.

Hi there. I have storm windows where the 'nub' on the corner pieces has broken off so the window no longer stays in the channel. Attached is a photo so would you be so kind as to confirm which replacement part I should order? Thanks for your time and assistance. -James

Hello,Hoping you can help. This is 1/4" x 1/4 "x 1.25". Thank you,Ranald

See attached size. We need to order several keys from you if possible.

I run into these windows everywhere in the mid Atlantic area. Cannot find parts anywhere. It is basically the same corner as you part number 95-254 but of course it is nylon and not metal and the dimensions are reversed from your part. Meaning it is 1/4" where yours is 7/32". And 7/32" where your is ... (cont.)

I have attached photos of the bottom window frame with left side latch still in place. I have also attached photos of the right side latch and spring. The catch on the spring did break when removing. I think the parts should be 91-001P for latch and 91-003 for spring. I could not find any names ... (cont.)

Slide Lock: 3" x 5/8" locking tab missing. I can only assume it is .25 to .5" Corner Key: 1/4" x 1-1/4" Cheap Plastic. Spring: 1"-5/8" including plastic keeper Let me know what you have please. (6) Slide Locks (6) Corner Keys / (6) Springs

Hello, I've recently taken apart the sash on my storm door. I'm looking for a source of the L-shaped fittings for all 4 corners.