Viewing all customer Discussions for:

21-016 Bifold Door Top Pivot, Fenestra

Accordion door hinge

I have two top pins, and 2 bottom pins missing

Hello, I need some hardware for some Fenestra metal bifold doors. They are interior closet doors that were probably installed in the 1960's. We have quite a few of them in a small apartment building. I'm hoping that you can identify the parts from my photos. I'd like to replace the hardware in one s ... (cont.)

My name is MonicaLooking for this bi fold door pin

Top and bottom connector to closet

I need to replace pin caps on several bifold doors. The measurements are shown in the photo but are as follows: Pin 5/16" OD Pin length 5 1/4 inch Pin cap hub 3/8" OD Pin cap flange 1/2" OD Thank you!

-On the top left picture is the door brand. -on the top right pic is the folding doors. -on middle left Pic si the bottom hardware. -On middle right pic is the top hardware. -on bottom pic is the broken top hardware part taken off the door.

I need to replace both pin assemblies on my closet doors. As they all look fairly similar, could you please direct me to the correct parts, please. pictures attached. Thank you!

Some of my bi-fold doors are missing top and bottom pins. Do you carry these parts?

Attached are pics of the parts.They are from a metal bifold closet door.

I need to identify, and then order a pin for a Fenestra bi-fold closet door. While in place, it measure 4.25 inches in length. I, unfortunately, do not have a picture of the pin uninstalled. If it helps, the door itself is 93.5 inches long. Thank you, Kevin

Looking for replacement part as described in photo attached. Can't seem to find a match on your site? Please advise. Thanks, Tom

I have looked at pin cap 21-106 for my 5/16 pin. Can you tell me if the bottom inside dimension of the cap is 5/16? The specs on that show only the top. If there is a lip on top this could be the one for my door. It is shown as a related part when looking at the pin with spring+cap or pin and cap as ... (cont.)

I am in need of several bifold door pins/pivots. These look very similar to the pictures from "Rochester". Do you know if that fellow's issues were taken care of by the pins you suggested? Thanks, Mike

Need pins to hold door on track