Viewing all customer Discussions for:

21-019 Bifold Door Bottom Pivot, Fenestra

Moved into a house with 4 sets of Fenstra bifold doors from the 60s or 70s. A number of the parts appear to be replaced a bit haphazardly. I believe I need part 21-019 for the bottoms, but I also need the bracket to secure them. Wanted to confirm. I've attached a photo of a top pivot pin that rece ... (cont.)

For Fenestra Incorporated metal closet door. 4" L X 5/16" W Need 1 of each photo.

I need spring loaded hardware for bifold metal 1970s closet doors

Good afternoon looking to get top and bottom bushings and pins for my fenestra bi fold doors tops are 1/4" diameter by 4 inch length with spring and push nuts. Bottom pivots are 1/4" diameter and 4" length and screw adjustable bushing that slides into track needs to be 3/8" thanks for your time ... (cont.)

I have old metal bifold doors and I can't find parts for them. Wondering if you guys carry them, there are a lot of options on your website.

Hello, I need some hardware for some Fenestra metal bifold doors. They are interior closet doors that were probably installed in the 1960's. We have quite a few of them in a small apartment building. I'm hoping that you can identify the parts from my photos. I'd like to replace the hardware in one s ... (cont.)

Hello Loren and Swisco Help Center, Could you please help me with getting the following hardware: Qty 1 Kitchen window lock for slider window Qty 4 Bedroom window lock for slider window Qty 1 Set of all hardware (excluding door handle) for Kitchen Closet for left door when looking at front of cl ... (cont.)

My name is MonicaLooking for this bi fold door pin

Top and bottom connector to closet

SWISCO: I'm looking for replacement part(s), assemblies for my original Fenestra metal bi-fold closet doors. The doors are originals from when my Grandparents had the home built in the late 1960s. I need part recommendations for both upper/bottom pivot assemblies, including all pin caps & push nuts ... (cont.)

House built in 50's. Caliper measures 1/4" on cap. So product code 21-018 seems to fit all measurements. Cap on this product says 9/32. Then I also need the top guide pin but the cap appears to be wider. First picture is guide pin. I have looked for a month and I finally found your company! Please h ... (cont.)

Hi, Here are the dimensions for the pins that we need. They are 4' long, the top part of the shaft has a 3/16" diameter, the lower part of the shaft has a 3/8" diameter. The metal dome on bottom has a 7/8" diameter. The top plastic part has a 3/4" diameter. Photos attached.

I need to replace both pin assemblies on my closet doors. As they all look fairly similar, could you please direct me to the correct parts, please. pictures attached. Thank you!

Some of my bi-fold doors are missing top and bottom pins. Do you carry these parts?

I need help with parts for this door.

These doors are 25+ years old still in good condition except for the hinge hardware would love to find replacement parts Fenestra Incorporated - Detroit, Michigan U.S.A.

Attached are pics of the parts.They are from a metal bifold closet door.

In the video, there are square holes on the door for the catch and for the clamp but my doors have a round hole as shown in a photo attached. There is no information about the doors except for the one sticker in a photo attached. I have 2 bifold doors that are missing all the top and bottom pins. ... (cont.)

Need pins to hold door on track