Viewing all customer Discussions for:

10-319 36" Shower Door Flap

Hi! We had to remove our shower glass door, and in the process, we lost the gasket/splines that went around the glass panel (likely thrown out). I'm trying to figure out what replacement part to use. Because I don't have one in hand, it's difficult to imagine which measurements on the spline relate ... (cont.)

This photo is of a gasket that seals the outer edge for the lower sash of aluminum Kinco windows from about 1993. The "T" shape of the gasket inserts into a thin track along the lower sash outer edge, about a 1/4" from the bottom of the window. The "T" shape measures 3/16". Overall, from the uppe ... (cont.)

I need to replace the rubber strip which seals my Aquaglass glass framed 22 1/2 inch shower door. The metal part is 22" long and it is 1" 3/8" wide

I need new shower door sweep for old shower door. Made by Aquaglass and is 213/8 long and on with no screws. Do you anything I can use?

I thought I needed Product Code: 10-326 but my shower part is two pieces. It looks similar to 10-326 but slides up under an affixed metal part that I believe is permanently affixed to the bottom of the shower door. My current piece slips under that part and is screwed in with something like 33-071. ... (cont.)

Looking for shower door gasket for Aqua glass brand shower. Gasket is 21.5 in long and slides into a channel on a metal bracket that attaches to bottom of door with 3 screws

Hello helpful and wise ones - I've attached two photos of our very old shower door. I think we need to simply get an appropriate door sweep and somehow affix it in the proper position. I'll go in and scrape and clean the metal as best I can but then what do you recommend to affix the door sweep to ... (cont.)

Where can I find a replacement? I submitted a few minutes ago and received ID # d164132 but I had an incorrect e-mail address on the request.

can you recommend any I tried 10-302 and 10-319 and both to small to fit in groove so I drilled 1/16 hole and tried to mount 10-325 and had the whole shower door bust on me

We need to replace plastic inserts on sliding door

Hi, My shower door bottom plastic rail broken need to replace. Could you let me know if your company sell this part or what kind produce and replace it. Thanks,

Hello I am looking to find a replacement for a rubber seal for the shower door. Can you please suggest a product?

I am trying to replace a shower door flap for a 20 year old Aquaglass Shower stall. I ordered Item #10-319. It fits in the slot of the drip piece but the flap portion that keeps the water in the shower is about 1/2" shorter than the original part and allows the water to leak out. Any suggestio ... (cont.)

Our shower door leaks. We removed the metal piece at the bottom an found the vinyl insert was worn away. The piece screws onto the bottom of the shower door. Can you provide either a replacement vinyl or the whole metal piece with vinyl that will fit the door? Length - 20-5/8" by 3/4" ... (cont.)

Hi- I want to know if a door sweep you have would be available. I would like to replace the sweep and not the whole drip and sweep. Also, do you have double tape or do I need to purchase it at a hardware store. This drip was installed that way and there are no screws.

dark grey sweep for bottom of shower door glass shower with metal frame total height is approx 3/4 of an inch smaller vertical piece is about 1/4 of an inch. longer vertical pice is 5/8 of an inch the groove is approx 1/8 of an inch i can't find any marking on the door about who made it ... (cont.)

The 10-319 shower door flap is a replacement seal that slips into a preexisting slot.