Viewing all customer Discussions for:

87-173 Window Roller, 1/2" Flat Wheel

Have not been able to find these anywhere.. can you help id and source this roller

I have 10 windows that uses the roller part that I supplied the pic for. Each window has four. advise if you need additional pics of the other sides of the roller. All sides are different. Thanks!

No numbers or name indicated on the existing parts. This is one of the two wheels for sliding window (3 x 4).

Looking for these window wheels. Thank you.

Can u help

I need replacement rollers for the window in a new to us house that I do not know the manufacturer of. PFA images of one of the rollers I was able to remove from the frame. The bodies are OK, the brass wheels were not cleaned, got stuck, and have flat spots worn on them. Full replacment or replaceme ... (cont.)

These roller are from Superior Aluminum Window products that used to be manufactured in the Los Angeles area. These windows were installed in the 90's. The brass wheels are 9/16" diameter, the part is 2-1/8" long and looking at the edge of the wheel the entire part is 1/4" wide. What would you sugg ... (cont.)

I'm looking for replacement rollers for some international sliding windows - die-cast housing 3/8" wide x 2 1/4"long with 1/2" or 5/8" wheel like the narrow one pictured

The plastic roller didn't work, maybe because the window too heavey.

Hi Swisco Part Team - I am desperate! Home was built in Vista, California, in 1989. I have tried 2 orders from your website and two rollers from Home Depot. I cannot figure it out. Thank you! -JT

Attached are 2 photos. The dimensions are hard to read, but 1 15/16" tall, 1/4" wide, and 3/8 deep with a 1/2" wheel. It looks like a Slide-Co# 17239, but not sure. I would like to purchase 10 of them for all the windows that are failing in my [old] house.

Submitting pic on seperate email of old sliding window roller assembly. Have 12 large heavy aluminum dual pane windows in Mexico and need to replace with quality roller assemblies. 2 and 1/8"tall, 1/4" x 3/8" wide with sheet metal screw to anchor in place. Windows were assembled on site three years ... (cont.)

Which screw might be most commonly used to attach this roller to the window frame?

I WANT BUY CODE 87-173 BUT THEY HAVE PLASTIC ROLLER BUT I AM LOOKING BRASS ROLLER, SIZE IS SAME. At LEAST I NEED 200 WINDOW ROLLER

Need a replacement for model 87-173. Would the model 87-196 fit? Thanks. John

Looking for the roller assy... see picture

I have to replace some plastic rollers for aluminum horizontal glass single pane windows made by international in 1976. The roller assembly is 5/8" deep, by 2" high, and about 1/4" thick.(They slide into the slot that is 5/8"x 1/4" from the bottom and held in place with a screw going through the ope ... (cont.)

Please let me know if you carry this part. Thanks.

I have extruded rollers for our double pane windows. The windows are heavy and have crushed and reduced the rollers to flat sliders. The brackets are grooving the bottom of the window frame. Do you have an equivalent replacement. 3 1-2" screw shown for scale.

I have a 1988 double pane sliding window - no brand ID- installed by builder. I am trying to replace broken window rollers for it. I measure the roller unit at 5/6" x 9/16" x 1 7/8". The 1 7/8" hight has room for variance in it. I can send pictures if it matters. can you help? Mark H. ... (cont.)