Viewing all customer Discussions for:

23-041 Mirror Wardrobe Door Roller Assembly

Good morning: I have some Stanley hanging mirror doors but not the top and bottom tracks. The top rollers are about 7/8

Please advise which product would replace the Stanley 17-4264Y-000 Insert. If you have a solution, can I just use your insert or do I need to replace the bracket too. thanks, JK

Hi-you will be receiving a call from Bob, regarding these photos and replacement parts. Thanks, Kate

Please help me find the correct door wheel replacement. Thank you. 4212

Hello!! I have a sliding mirror door that I would love to keep out of the garbage stream. It has convex "wheels". I would need a new 5' track-- but I also need some new rollers. You can see the little plastic part on the wheels-- I have 2 intact, and I need 2 additional. Or maybe I need to replac ... (cont.)

What roller? It's not a 23-225. Note how tha back tabs are different from your 23-225.

Does the track for the Swisscom product #23-041 come in ten foot lengths ?

I need to replace the white plastic wheels that are completely gone from one set of my doors. It is marked ACME 4011 and us pat 3.058.173. Where can I find what I need?

Hello, The bottom floor metal guide has 2 tracks and is unmarked. The Stanley mirror doors have Stanley bottom roller part# 4212 and 17-4264Y-000. Do you know the model number for my bent and rusted bottom track guide? Thank you, Michael

current units are marked Stanley 4011 roller diameter is 1 3/8" width---3" height--3 5/8"

I have two mirrored closet doors that I want to to install but don't have the tracts, top or bottom. Can you please help me with this.

Can I obtain instructions for installing doors (#64564-001)? Watching some youtube videos re: installation and I understand there may need to be a 5/16" (or ?) off-set for the upper (lower?) tracks.

the doors are 78"x30"

There were plastic pieces in these that were broken, I need something to replace them with.

Fantastic! I am so thankful to have something go so smoothly, it was a welcome change. The not so tough part was removing the old parts, but just cliping in your replacement parts and a few turns of the screwdriver for adjustment and it was done. I replaced my Stanley upper glide part # 00-5024 wit ... (cont.)

Trying to find this part

Hi! Just to confirm, from reading other posts I am gathering that Stanley door 4011 hardware is replaced by swisco part 23-041? Our little plastic wheel is looking quite flat on one side, so that should fix it! Thanks so much!!

Do you carry a roller assembly to replace this unit? It fits on a mirrored closet door with a wood oak frame.

How do you remove the old Stanley roller and install the new 23-041 roller on the mirrored closet doors?

Hello, Do you sell this item?