Viewing all customer Discussions for:

23-064 Mirror Wardrobe Door Roller, Concave

Do you have the 1-1/2

one of the wheels stopped rolling and I need to replace it. I prefer to replace both of them. There is a sticker on the door from Charmac, Inc as the manufacturer of the sliding wardrobe mirror door

Hi - I am looking for a roller assembly like your 23-064, but I need to know if the concave wheel is 5/16" wide. The only number I found is on the actual wheel - it says Toronto Canada 9360. Thank you for your assistance. Margaret Estenes

I need several replacement mirror wardrobe door roller very similar to your Product Code: 23-064. There are some differences (e.g. my wheel is 1.5 inches) but the key similarity is the the ledge that sticks out to hold the door. I have looked everywhere but have found nothing that is as similar as ... (cont.)

Picture of my Sliding Closet Door wheel assembly. Looks close to your part # 23-064 however, the vertical hole-to-hole height is 2 1/2". Your part looks a bit taller... No markings on the door or wheel. Any advise or guidance? Thanks...

Can you identify this closet door roller?

Please help me identify if this part is avaialable

will 23-086 replace 4850145 THM?

I would like to locate a couple of wheels for the mirrored closet doors made by Contractors Wardrobe. The ones (wheel housings) I have seen so far on Swisco do not seem to be exactly the right size. The bolt holes all seem to be a different spread than what I have. I would of course desire only th ... (cont.)

charmac inc is the company stamped with patent # 4850145

I need a replacement part. See attached photo. The plastic wheel broke. The Charmac, Inc. sliding glass door was installed when the house was built in the early 1990's. Patent number USPat 4850145. The letters TMM are below the patent number. The casing is 1.5 inch wide. Let me know if you ... (cont.)

I am looking for this part for my closet i am having a lot of difficulties finding it. Thanks in advance Maria.

Hi I tried upload a video but it would crash the browser. This only needs two screws to mount. If you just have the lower wheel assembly I would be fine with that. Thanks Lance

These are from circa 1965-1970 and go on the bottom of floor to ceiling mirrored closet doors used in apartment buildings in Palm Springs, CA. There are three doors (1 mounted on rear of track, two mounted on front of track) and the front-mounted doors need to slide past the middle (rear-mounted do ... (cont.)

Please send me prices on the wheels, thank you.

I Need a replacement roller and housing for contractors wardrobe sliding closet door. The CW part number is p/n w8025. Do you have this part? Thanks Josh

Can you help me identify and locate this roller?

Please let me know if you could help me locate something as a replacement. Thank you.

I need to replace a roller that only has "U.S.Pat.4850145" and 23-028 was recommended in your blogs but my roller mount is on the opposite side. Is there another option?

Hi, Part measured 4"x3.5" and the main body is 1 5/16". It attaches with one screw on the outer flange and the bottom clamps under the frame in a "U" style. Looks like a US patent number of 485014 is stamped on it. If you have them, I would prefer to purchase 4 of them. Thanks, Keith ... (cont.)