Viewing all customer Discussions for:

81-098 Pella Patio Glass Door Roller Assembly

I need to replace the roller wheels on my Pella Designer slidint patio door. The model numbers that inside the fixed panel is as follows. PELLA-PEL-1205-D2CSFVF1Z1-071E081/WHT-525SV15S-NFRC I'm also curious if the metal tack that the rollers roll on can be replaced. Please let me know, Thanks ... (cont.)

Dimensions 1 3/4 x 2 3/4 x 3/4 there are no numbers on the parts. Please help me identify replacements.

Unfortunately I did not take measureements before reinstalling the rollers so we could close the door. Hopefully you can identify it. It sure looks a lot like the rollers I recently replaced on a Pella sliding glass door. Thank you, Sean

Roller for 8 foot Pella patio door built approximately in 1995.

The is a Pella slider door. I need new wheels. I have no reference to the type of door. Anyway you could tell?

Width 5/8", height 1 11/16", 1 1/2" diameter wheel, length 2 3/4"

I didnt' take pictures installed and now the door is back in place awaiting new parts. I hope the pictures are adequate to find the correct replacement.

The roller is broke as well as the lock

I need the replacement rollers for my sliding door and the latching mechanism. I have attached a photo of the model in the bottom right of the glass.

I have a Pella patio door and my rollers are worn your product code 81-098 seems to be the one I want, but it does not have ears to prevent it from fitting too deep into the door.

Length 2 3/4" width 11/16" height 2" wheel diameter 1 1/2" axle diameter 3/8" height adjustment screw at top of housing

Roller is off a pella door, aluminum clad with wood interior and blinds in between the window pane. Please help identify the roller I need to get two new ones.

This is a roller from a pella sliding glass door that I believe is from 1984 per the glas

Bottom adjustable roller sets, one on each corner, total 2 needed for left and right. Sliding door is wood framed, no visible ID.

I unfortunately don't have all the information you generally seek. But I have an older Pella doorwall. I was unable to find any numbers or markings. My rough meausrements of the roller indicates a length of approximately 2.75", a height of 1.75" and a width (excluding the flanges) of roughly 0.5 ... (cont.)

Hi , I have a 20 years old Pella sliding door that needs new rollers . model 7282 designer series. Thank you

Needs replacement

No numbers on part. See pictures.

Hi, The bearing on my sliding door went bad, so I'm looking for a replacement. Outside housing is 3/4" wide and 2 3/4" long. Thanks, Andy