Viewing all customer Discussions for:

23-172 Top Guide

Please help me find a replacement part. See the picture for the part fitting into the top of a closet bi-fold door. It may date to the '50s. The top edge of the nylon wheel sits inside the channel above the door. The channel is attached to the bottom of the door frame. The lower edge of the wheel is ... (cont.)

I believe the 23-172 is for me but the barrel is 3/8.My measurements show closer to 7/16. I expect that will be a simple fix of wrapping it some durable material. Does this look compatible with my Stanley Stepped/Falnged Guide Wheel?

Upper bifold door guide. Lip rides on channel not in channel. 1970's era hardware.

I need to find an additional top swivel bracket for a ~ 1980 vintage Stanley bifold door kit. Looks like the pictures. Bracket is 1.125" wide, about 2.25" long and inserts into the track shown in pic 6539 that has a profile 1-3/16" wide and ½" tall. I also need a lower pivot bracket but haven't take ... (cont.)

Looking for top plunger guides for bifold doors circa 1974. They have a ridge on them and I cannot find any to match. Please see photos.

I am in need of several roller guides. "ACME" is faintly stamped on the barrel. Top diameter is approximately 13/16". The very worn flange is about 15/16".

Please help me to identify a replacement part for the attached pictures of a Stanley roller dating from 1976.

Need a plastic roller that goes in the track. The track measures 1?.

My existing top roller guide measures as follows,Roller = 13/16 in dia.Core dia. = 3/8 in dia.Core depth = 1 inch On line I can see product code = 23-114 but it appears to be a little large than my existing part.Can you supply one to match my existing part?Best Regards,Tony

Please help identify this roller. Thanks.

I am looking for a replacement top guide roller for my bifold closet door. The top guide has a lip on the roller that keeps it in place. I can't find a guide roller with that same lip.

I purchased two 23-172 spring loaded top guides for my closet door. It is 13/16 diameter. I did not measure correctly when I purchased and they are too big. It looks like I need a 11/16" or even a 5/8". Do you have something in these diameters? I like your construction and if you don't I may just or ... (cont.)

We're looking for Bifold Door Top roller guides smaller than what we're finding at DIY stores, we need a smaller roller, apprx. 1/8" tall and a little less than the 7/8 OD Would you have anything or can you refer us somewhere ? Pls. advise, Robin S.

do you have a door roller like this? thanks