Viewing all customer Discussions for:

32-089 Drawer Track Back Plate, Pair

this is a two part bracket first part number is h-104 that I can find second part that is broken is part# h1043 wich slides into h104 supports a glide for a trash can cardell was the cabinet company

Hi- My kitchen drawers are made with Unigrass 6000 epoxy coated slides. The drawer side has the slide integrated into it. The attached photos show the uninstalled cabinet slide, the broken (right side) part that I need to replace and the unbroken left side installed. The cabinets were built ... (cont.)

what is the measurement of the opening of 32-018 drawer socket

need rear drawer track socket for Hettich 602 track left side

I cannot find the correct bracket for my rental property. The only markings on the bracket are LDP-3. The height of the bracket for the slide is just one 1 inch.

All of the rear mounting brackets I have been able to find are for rails that are smaller (Euro style). Cabinets were installed in 1994. Brackets are made of plastic. Dimensions enclosed.

Hi, I'm looking for a replacement bracket for the right side of my drawer slide. The mAtkins on it are as follows: G * 6020-6 PH. The letter R is also on it- I'm assuming that means right side. Thank you!

Had an earlier post with no answers

Do you have one that is a 1/4 inch wider for where the shelfing bar is slid in and being held in the plastic sleeve?

# 32018 what is the length

I am looking for multiple pairs of rear mount drawer slide sockets. The overall length is 3 7/8

It says On the Bracket G*6050. Do you have a replacement for that Drawer Slider Bracket? Thanks

I have mounting brackets that are two different colors, but they are the same. They can accommodate a 1 inch wide slider (attached to my drawer.) The standard bracket at Lowes are just a little too small. The bracket says G* 6620, and to the right it has an R inside a circle with a number 3 above it ... (cont.)

inside measurements of item 32-119 and item 32-108 rear drawer guides.

Looking for replacement rear receiver brackets like the one shown here. The guides on both the drawer and the cabinet do not have any names/codes that I can see. The guide that goes into this bracket is about 1

No Markings except R (for right). Slide channel is 1" x 3/8". I can't tell if the bracket slants up to match the slide, if it does it is very slight, Maybe why they fail.Overall length is 3.25"

Hello, I have a 91 year old step dad living in a mobile home here on my property in Hope, Arkansas. I am in need of some Wesco-Fastec cabinet drawer end sockets to repair his kitchen cabinet drawer slides. A picture of the end sockets is attached and need 6 of each, left & right sides. Contact ... (cont.)

Rear mounting brackets like your 32-014 I need them with a 1 " opening. Do you have them?

Hard plastic, back bracket to secure hardware, at least 20 years old, Broken part is on the left side however looking for both sides

Please tell me whether you sell a replacement for this guide. Thank you.