Viewing all customer Discussions for:

26-362 Sash Vent Latch

Do you have a replacement lock mechanism that fits the 700 series for this window? Thanks.

Looking to replace this item. The lock pops out from the vinyl insert, but now it stays out. I cannot find it anywhere! It's 1 1/2" long. Thanks for any help!

These locks are breaking to where they will not stay in. Patent pending number on the part is 5,806,900 and the window is made by Radiance.

I need a 24 by three-quarter inch Channel balancer. I need the left and right. I need a night latch that is one and a half inches.

I’m looking for a replacement night latch

I need two of each of these parts for our windows. Any chance you have them? These are the only numbers that I could find-Security stopper: Patent pending # 5,806,900Guide slide has i3L and also 075Thanks Brent

I there are two kinds of parts I need for my Provia windows window limiter( stop lock) and brass wheel assembly hoping you can help me out with this thanks

These do not work any longer they stay popped out. I need to get replacements. Where can I find these?

Need the pivot bar and whatever the white part is.

Please assist with identifying this part. Thank you!

I'm looking for several replacement parts for Universal Windows 7400 series windows. I found 2 of the parts on Swisco but I'm not certain about the "vent stop" or "vent latch" if that is the name of the part I need. My customer called it the safety lock.

I don't know what this part is called that allows me to open the window only a little so as not to allow the window to be pushed up higher, but normally fits flush with the window case

I'm looking for a replacement child lock for an alliance window it is 1 5/16 high by 3/8 wide, I'm not sure if you make something that will fit or not

I need four of these for a couple of windows that I have. They are used to prevent the window from opening too much to prevent children from falling out. They are inserted in the top portion of double hung windows. Thank you!

sash vent replacement. Quite a few in our recently purchased home are broken.

Hello, These pictures were sent to me from our maintainance department. Any help in identifying what parts we need would be helpful. Thank you!

Hello. Above shows the latch not installed; in closed and open position.The second photo shows the latch installed.How am I supposed to remove the broken/inoperative latches without damaging the window sash?Thank you,Richard Troy, NY

Snap lock that allows window to be open about two inches and no further. It no longer stays closed to fully open window. Where can I find a replacement?

Slides into holes on each side of the vinyl window to prevent window from opening any higher.

I am looking for this part. This part on my window will not stay in and I have to open and tilt the window to open. Please advise if these can be purchased and installed. Thanking you for your prompt attention to this matter