Viewing all customer Discussions for:

36-019 Torque Bar Bearing, Each

Need this bearing for a two pane glass awning window. Do you have a local dealer near Tampa?

aluminum awning bearing piece for bottom tube on window.

Bearing part on the bottom of window. Fits tube across bottom.

Aluminum window guild from like th 70s

Please identify and let me know if I can order these, thanks

Re: damaged crank system of my 4-pane awning window. Looking for this part that holds the aluminum rod in place at either end.

The small plastic part that secures the crank basis missing on one side and damaged on the other. Pics are the part, where it goes, and the window.

I need two of these parts for my window. It's broken and the pivot bar is loose on the left side. It's an old window for a house built around the '60s. Please tell me if these parts can be substituted by one of yours.

This part is from a 25 year old PGT 4 pane louvered window. Lower rod retainer. Looking for 16 parts.

A plastic bracket that holds and houses the bar of the lever mechanism. Circa 1983. Location of bracket is within the window frame, at the bottom, on both sides of the upright section of the frame. Purpose: Holds a bar in place while lever mechanism leverages itself in and out against the stabilize ... (cont.)

Good day! We snapped three bottom roll bars' plastic pieces that lock the windows once we want to close them. Are we able to just purchase the plastic end piece or replace the entire bar? Either way, where can we locate these part(s)? I think these windows are from the 1960's. Your comments wou ... (cont.)

Its the idler end of the rod at the bottom that the crank turns on a 4 section crank out window. The little gear box is on the other end.

1960s jalousie window 52w x 62h w 3/4" torque bar. Can't find mfg number. Need replacement bearings. The bearing measures 1x1.5 with screw holes at the top 1 3/8 on center. Thank you very much!

Hello, The plastic clip at the bottom corner of my window has broke. It's difficult to get a great picture, but I've included two pictures of the clip & one of the window. Do you carry this part?

ITS MADE OF PLASTIC

I have awning windows and I assume this is a torque bar bearing. The part is broke.I think it may be Pan American windows.

Holds tube in place so it can turn.