Viewing all customer Discussions for:

55-180 3' Snap-in Vinyl Glazing Bead

I am looking for glazing bead for my double pane Better Bilt windows that I am assuming are original to the house (house built in 1994). The glazing has either separated from the window, waved or is missing in some cases. The glazing has a curved side that snaps in between the window and frame. The ... (cont.)

Please confirm that your Product Code: 55-180-6 is the most likely match for my application. Attached is a cross-section photo and dimensions diagram for the vinyl glazing I need to replace. Note: the dimensions are the closest approximation I could get with my calipers on the slightly deformed ol ... (cont.)

Hi. I cannot seem to find this glazing anywhere. They all seem to be much wider along the top portion. Please let me know if you think you carry this or something interchangeable with it. Thanks!

Silver AAMA label on window Mfg code DAN-1 series 300/700 HP ANSI/AAMA 101-88 DH-R25/DH-R30 (Modif) MST 3860 Looks similar to Swisco 55-180 My dimensions (best estimate) hook side 1/2 inch top side 3/16 drop down side 3/8 bottom of L side = 11/32

I

Windows I believe to be AAMA series 300/2300. This is the only info I found on the windows. My customer has about 9 windows that need this bead replaced. I have been trying to find a match. Maybe you guys can help me out. Thank you.

I attached a picture to the part number of my window. The interior glass trim piece broke that I am holding in my hand in the second picture. I need to order a new one. I also need 4 lock latches for these windows. Any help would be much appreciated! Matt

Windows frame

I'm trying to locate materials to repair my windows (see image). I can't locate the correct item... Any help you can provide to locate the part numbers, I would be greatly appreciated. Thank you...

Windows are original - house was built in 1997 - DR Horton. I believe the windows manufacturer was Capital, but not 100%. White Bead, Front of bead is 5/8", back of bead is 1/2". Can you recommend a replacement?

Please see attached photos. The glazing in the photo is 1/2 inch by 3/16 inch (approx).

aluminum single hung window. labels are not legible. approx. 3/4" across the top approx. 1/8" in the middle. longest leg is 5/16" short leg is 1/8"

I have a HR horizontal rolller window, and I need a glazing bead replacement. White with width 3/16 and height 1/2. I also attached some pictures, they could give you more accurate in measurement. Thank you!

I need to replace the snap-in plastic bead on my 1994 windows. I think they were built by Atrium, but I can't be sure. The manufacturer's code is AB-1, series 1200. See attached picture. Thanks.

I need to replace some of these strips due to hail damage. I have looked at your strips but don

No names, no markings

I'm looking to replace some damaged vinyl glazing bead on my windows. They have a Ga on the locking mechanism. I ordered the 55-180 and the biggest side that is exposed is too small at 7/16". As you can see in the measurements I need it to be 9/16". Do you have anything that will work? ... (cont.)

Help need to find glazing bead that is identical, or closest match. So far found some similar but missing the > "fold" that sits underneath glass, have found lots of flat ones. Any help would be appreciated.

I am replacing a lot of the plastic window strips and need to know which one this is.

I need help identifying his snap in glazing for aluminum window