Viewing all customer Discussions for:

26-374 Andersen Sash Pivot

Looking for a window sliding part see picture attached the window brand is Anderson. This piece got cracked

the little plastic thing slides in a channel, helps depress the sides to tilt out window for cleaning. on the door, the fake dividers are falling apart, could use replacements. they just wedge in

need a couple of pairs for left and right sash hinges. ( for tilt in lower sash )

Hello: I’m looking for side mount pivot bars. I’ve attached two photos. They are for the coil balances I purchased earlier. Please let me know what model of your stock might work. Thank you, Charles

The pivot post on double hung windows Measures one and 3/16 inches long 5/8 inch wide and 5/8 inch high

wood windows could be from 2010need tilt latches & side pivets

I need these

Hello - I need to replace a sash pivot. I think it is 26-374 or possibly 26-406B. My part has two screws, but those look to only have one. Please advise, thanks!

Can you please identify what part this is? We believe it to be a pivot pin

I have this older window in my cabin 34x46. It is a slider and tilts out and the balance is broken but can't seem to find the right replacement. When I took it apart the spring was on top and the cord was attached to the bottom. The 23d is the only markings on track. I will need to replace the b ... (cont.)

these are the two pins at the bottom frame of my double-hung vertical windows. Bent and broke off at screw hole (drawing shows remaing half still attached to frame)

This piece has broken off from the bottom of the window. The manufacturer is shutter craft.

One of these broke and I can't find a replacement. the part is 1" long and the pin section is 3/4" deep

Can you get your hands on this pivot? It's an Anderson window. I'll need two of them. Thank you.

Good Morning! Below is pictures of the following part we're looking to purchase for replacement part for are window. The length of the pin is 1 5/8" long. Look forward hearing from you soon.

These latches slide into the top of the sash from the side. I also need both of the lower pivots and two of the screws.

Need 6 metal prongs and 6 3730's I do not know how to get gliders out.

1991 double hung window. bottom mount square bar two screws. one screw on sloped surface. looks similar to anderson sash pivot

Swisco, I have a few broken sash pivot pins that need replacing. The sashes were made by Pella and are dated 2008. There are two similar pins listed on your web pages that might be used as a replacement although I will need to alter their dimensions for a proper fit. Your part numbers are 26-402 (Si ... (cont.)

trying to find a one screw pivot