Viewing all customer Discussions for:

39-353 Hope Operator, 4-1/8" HCs

Good Evening,I am attempting to find a replacement crank for an old window in a home a client of mine is purchasing. The contractor has informed me the window will not close because the crank is broken. However, he is unsure if it is the crank of the mechanism that is not visible. The cranks were pa ... (cont.)

Need operators for steel casement windows. Old Hope's pictured below. 9.5 inch arm and 2 and 3/4 inch opening for the arm. Do you have anything ?

9-1/2" long between center pivot to center pivot. 10" long arm tip to outside bend. Stamped HOPE'S A 90 L. Also stamped EMSCO. Thanks for checking, Fred

I need replacement casement window crank operators, both LH & RH, for the type of hardware shown in the attached photographs. The length of the arm looks as if it is 11" (from the center of the button to the center of the mounting body/bracket). The screw holes appear to be on 3-7/8" and 4-3/4" ce ... (cont.)

We have old Hope operators in a 1950's house. The arm measurement is 9.5" rather than 9", measured as you show in the diagram. Will yours work OK on our windows (i.e., just shorter swing-out)? The crank on ours is not centered on the base, but offset a bit. Is that also OK? The 4-1/8" screw mou ... (cont.)

The only markings are "HOPES" and "Jamestown NY" on the top and "L.H." on the underside. There are no other numbers or letters anywhere.

Hi we are renovating an old building with Hope casement operators. Please provide pricing for 47 right hand and 9 left hand operators in bronze.

Hello, I ordered a 39-353 Hope casement operator a while ago to try out as a replacement for our original 1950s Hope operators. (Most of them still work, so we have some good ones to compare the replacement with, but there are a few that no longer crank and we're hoping to get those windows worki ... (cont.)

We are looking for window replacement cranks. Do you have anything that matches the size below. Thanks Suzi

Greetings: I need to replace four Hope window cranks and arms (the teeth are stripped). The original part number is R. H. 5564. The screw holes are 4 1/8" apart. So far, so good, right -- because that would seem to match up with your 39-354. But there are two issues: First, the length of the ar ... (cont.)

also need Right & Left closure locks.

Need some of these have tried some Home Depot aftermarket but don't last long! The screw holes measure 41/4" and the length is 9" and the name on the unit is fenestra on early 1950 steel casement windows that are about 2' wide and 3'6" tall

Dear Sir: Looking for replacement parts for some vintage Hope units. Quick measurements: Casement Operators with mounting holes @ 4-1/8" C/C Arm Length from mounting base to center of circle (that connects to actual window swing) = 9-1/2" (I can re-measure if you have a preferred way) ... (cont.)

I recently purchased hope operator (39-353 and 39-354) 4-1/8" HCs from you and it was perfect. I now need the same operator bfut with a 6 inch arm. Do you carry this?