Viewing all customer Discussions for:

67-026 Face Guide

Do you carry this little nylon guide that snaps on window edge.

hi my window from 1996 is broken. I need that plastic piece on the right. I'm sending you pictures again, but I also need to know if you sell that plastic covering that goes on the top little corner and if you sell these little white things each window that I have is made by you because the book say ... (cont.)

I have a single hung original sliding window in the bedroom from when the house was built in 1997.The plastic clips on the side of the window as demonstrated in the pics are deteriorating over time and some have fallen off. I am not sure what they are called and am wondering if you happen to carry t ... (cont.)

Does that clip help it from going side to side? Because I'm missing a couple of them in each window.

Need 2 balancers 30" - see pictures attached Mark 40/50 SH FIN H-LC35* 120x77 (mull)

Lastly, the face guide. 1/2 x 1/2 inch. Thanks.

NEED CHANNEL BALANCES THAT SHOWS A DESCRIPCION BUT I WAS UNABLE TO FIND THE PART NUMBER. ALSO NEED THE TOP SASH GUIDE PN 18-188 AND A SMALL CLIP BELOW ON THE PICTURE.

Hi, this is a snap in windowsash glide. Do you have this part? I need about 18.

I have a lot of windows where this little clip has broken. Please let me know if you have it available for purchase. Thank you

Hi, I'm currently trying to replace all the sash guides in my house as a lot of them are broken and don't hold the balance anymore. I know the specs of the guides I need but am not sure which piece will be the best fit. I was unable to find any markings or identifiers on the sash or the guides. The ... (cont.)

My apartment has these single non-tilt windows and this part is missing from a lot of them. It helps to keep the window in place, but I'm having trouble finding the correct part.

the clean white face guide is part number 67-026. I was trying to replace the old ones that you see in the picture. They are both 1/2 wide, but the old one is only about 7/16 or less depth vs. the 1/2 depth on the new one. Just checking to see if you happen to have it. thank you. ... (cont.)

These pieces are at top and bottom of opening sash. They measure about 1/2 inch square.

number 29-4 EA2 CMC 12 metal shaft length 30" weight 24 lbs Need channel balances & little neoprine spacers that recess into window to reduce friction & keep the window tight to the frame

These are some type of sliding window guide.

Looking for the part number for the top sash guides for these windows

Previous customer here. Hoping you have replacements for the missing parts of model window in question. Both shown in pics. Part seems to be a stop to keep window from having play side to side. Please advise. Thank you so much.

I need these window glides

Looks like top sash guide on both corners is broken. The width of the channel is 0.5 inches. I would also like to know the channel balance replacement part for my existing channel balance. The channel balance marking is 17 2

I need your help locating top and side sash guides. Each window has 2 top sash guides and 4 side guides. I am uploading pictures.