Viewing all customer Discussions for:

87-188 Sliding Window Roller, Two 3/8" Nylon Wheels

I'm replacing the window rollers on 3 windows, 6 dual rollers assemblies. The track with is - 7/16" with a single fastener. Do you have replacements for this.

bottom-mounted, center-grooved sliding window roller set in a plastic housing

If you can send me a email address I would be more the happy to send you pictures and meassurments for the window roller i need. I have to do it with my I pad and then email it to you. give me a email contact and I will get pics and dimensions off to you to analize. I am a home owner in Montana ... (cont.)

The overall length is 1.924", width .3050" ,screw hole center is 1.6285" only one screw holds it to the window frame. The low height is 3025" the taller section is 375". The rollers were missing. House was built in 1985

1990 windows I need replacement rollers see attached pics

Hello, I am looking for a pair of the rollers for a sliding window.

GA is stamped on window latch (probably General Aluminum). I am trying to replace 6 of these to make opening the sliding windows smoother. I'm handy and may try to fabricate a solution if you don't have anything that will fit. Thank you very much. Jeff

Hi, these are wheels to a Sliding Window to a Donut shop drive through. I would need 12 pieces. Internal Quote # 1-12018 Ty - T

Roller on the bottom of an aluminum sliding window. Single, flat, metal wheel. Window track depth is 3/8" and track width is 7/16". Groove width in the window track for the plastic roller part is 5/16". Entire roller part is 1 1/2" long, 5/16" wide and 7/16" high.

I went through all of the roller assemblies on your site looking for a match to this roller, but to no avail. The windows are single pane and reasonably heavy, which explains the brass rollers. The initials P.G.T. are found on the locks and the weep hole covers are embossed "P.G.T. Venice, FL". S ... (cont.)

the part i'm looking for looks like a sash tilt latch. They fit into the top of the stiles and seem to act like a guide and retracts for window removal. The sliders are approximately 38" x 60". If it helps I.D. them, the wheels i found are P/N 87-188The name on the locks is Pennco Inc.. vinyl slidin ... (cont.)

5 windows 2-each need help identifying/locating.

Hello, I have several dual pane horizontal windows that are missing small wheels or they're broken. I can't locate the manufacturer but I do see some small faded info on the glass that says something like LP ws-5 93-2. Thanks!

Hello, I am looking for the wheels for these. Preferably, steel or brass. They are 3/8 O.D. wheels. Thank you!

I would like help identifying the replacement wheels and the housing that holds them. I would like to be able to purchase the wheels individually if possible. These are from a Milgard window. I believe the Classic Series. The housing that holds the wheels are 2-1/4" long. The mounting screw holes ... (cont.)

Need replacement for these part

I've got these wheels on the bottom of a sliding window in my house. Some of the wheels have a flat spot. I can't seem to find the exact parts on your sight. I don't really need the exact part if there's something that would also fit and work better than the original wheels.

I am looking for a roller window assembly for a Pennco sliding window.2020 series. Thank you

Can you help find this replacement part?

Length 1 5/8 Roller width 3/16 Plastic width at top 1/2 Plastic width at bottom 5/16 Original windows from house built in 1981. Thanks! George