Viewing all customer Discussions for:

32-118 Back Bearing

These are for a Bassett, Cherry dresser. I bought about 15 years ago. I need the white piece to fit on the wooden rail in the bottom of the drawer. Attached are two pictures. Please let me know if this is the right one. Thank you.

Hello,We've got a couple of these drawer glides/slide broken. Could you help me find some?Yes, I realize that I might be asking the same question asked above?Thank YouJim

Looking to replace a broken drawer rail (15 1/2" long by 1 1/8" wide as well as the rail guide. See photos for both. The photo of rail is a good version that is usable.

I need to replace 4 drawer guides for a Fisher Price dresser/changing table model number 9551 from 1988. I also need small round grommets that hold a swing arm to stop the drawer from falling out. I'm not even clear on how these work because only one stays in the upright position..the silver bar g ... (cont.)

I need 20ea for this drawer guide. Thank you

For a dresser.

See pic. Do you have replacement for this?

The opening size is 1.2 inches wide. Total width is about 2.45wide Total height is 1.9 inches height of bottom openingis .32 inches, the square area where the wood rail is .3inches high by about 1.2 inches wide. It about .52 inches thick at thickest part

need to replace the plastic drawer guide which measure 3 1/8 length and 1 3/4 width.

I need one drawer glide with a 1 3/16 by 5/16 glide opening. I believe your #32-118 would be a good replacement. How do I order it or where can I buy it?

I am looking for a drawer guide for my Thomasville dresser. All of the guides I have tried do not work. The small piece on the upper right corner broke off.

Looking for drawer guide for chest by Pennsylvania House Furniture, (a small 3 drawer chest of drawers) Plastic guide is stapled to drawer, labeled RONTHOR REISS CORP NYC R-40-28. Measures - 2" Height; 1 1/4"width of guide slide; 1/4" width of elbow that holds on to the glider on the base of cabinet ... (cont.)

I need replacement brackets for 2 draws. Labeled.R-40-28

This is a rear dresser drawer guide, about 20 years old. I couldn't get all measurements as the tips were broken off. Thanks for your help in identifying the part number, so I can order a few. Ken

RONTHOR REISS REAR DRAWER SLIDER 40 28

Need to replace some rear drawer guides on dressers that were bought about 35 years ago. Guides were made of Teflon, and some finally became brittle and cracked. The design of your guide 32-031 seems to be the correct one, but some of the dimensions I measured on the intact ones vary just a small ... (cont.)

Need a few of these for a dresser drawers. These are 3 inch wide

Do you carry something like this? Have purchased from you in the past. My go to for odd pieces I need when something breaks

This is from a bedroom nightstand which l bought from Oscar Huber back in 1992. The old bracket is stapled to the back of the drawer. Do you have this part and it made so l can fasten it back on without staples. RONTHOR REISS CORP. R-40-28.

Missing a drawer glide as pictured. It is 15" long and has Pat. #3185530 on it.