Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

This is a unigrass 6600 drawer socket. Need replacements and can't seem to find.

I have old shrock kitchen drawers and the plastic back plate cracked. The track has a width of 1 inch and the it seems that the plastic back plate is 1 1/16 inches wide.I called Shrock and they no longer have any parts.The glide is 21 1/2 inches long and the back plate is 3 3/4 inches and the tra ... (cont.)

rear drawer bracket/stop for 1960's Scheirich cabinets basically measure 1.5x2.5x13/16 See photos thank you for any assistance.

Do you sell these? If not, where can I get them in addition to from Yorktowne?

What part number do I need to order. Slide is 13/16"

Need 4 Plastic round socket bracket holders for Kitchen Cabinets

Hi,I need 4 replacement parts as seen in the photos. Please let me know how I can order these.Thank you,A.

Please send me 2 left side and 2 right side replacement parts.

I am having trouble locating a replacement part for this rear bracket. The drawer slide is stamped G6600

This is an older lower cabinet with slide out shelf. The brackets that attach to back of cupboard are broken.

The patent number on the part is 4930739.

This drawer guide broke in the back of my drawer. My house was built in 2003. I can not find this piece anywhere but saw a picture of it on your page. Do you have this piece or have one comparable to it.

Rear bracket for drawer slide. Rail is embossed with a G. Not sure which bracket to replace with and then howtogetold bracket out. Thank you.

Good morning , I am looking for a replacement for this bracket that broke after 30 years . It has the number 471029 inside and the word Left on the outside . It holds a sliding shelf in my oak cabinet . Thank you very much for any assistance !

My kitchen cabinets have plastic parts that have begun to crack. The part I need is shown in the attached photo. What is the model number of this part and how may I obtain it?

was needing for pmi-cm565R Drawer slide

6600 on track

These were used with unigrass 6600 drawer glides. No screws or nails just knobs on the back of the socket.

Hi,I was wondering if you would be able to help me locate the plastic boot guide for our drawer that is pictured. The left side broke and needed a replacement for the plastic piece.Thanks in advance!Stephen

Do you have this part that is broken on the wall, so the drawer can be put back in?