Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

I need a new pair of these.

I would like to buy 5 of them

I have 3 kitchen cabinets from Kraft maid cabinetry. And the slides are worn.

30 year old Merrilat drawer back of cabinet socket that we found out had 2 dowels inserted in the cabinet. After removing the broken pieces still attached to the cabinet, we had a heck of a time trying to get the final 2 pieces out. They wouldn't pry off, so after thinking about it for awhile, my ... (cont.)

Help Identifying Hardware.

Do you have this part of something that will work? My cabinets are only 6 years old.

No markings

19-04, and I already purchased the 32-04 rail bracket from Swisco

Kitchen cabinet drawer Rear socket

Img 8442 is right side drawer guide . Img 8445 and Img 8446 is actual left side drawer guide. The cabinets are Kent Moore 2007 install.

Need new sockets for drawer guides

Hi, this bracket broke. It's from a Haas cabinet circa 1995ish. My Dad could use 6 of these if you can help us figure out what it is. Thanks! ps you were recommend by Bostwicks in Elmer

Need replacement right side

The plastic going into the wall broke away from the drawer side rail.

Bracket for a side mount drawer guide 2" tall 1.5" wide 3/4" total depth 2 round parts in the back stick out 3/8" past flat back. They are 1/4" in diameter.

I want to replace some drawer sliders. They have a bottom edge that the drawer rests on but the screws need to be on the side because the bottom board is not thick enough. How do I decide what length I need? The actual piece of metal on the slider in the picture measures 22 3/8 inches. ... (cont.)

I'm looking for the part in the photos.

I am in need of the rear drawer socket for a Merillat Silverware Drawer Cabinet. I have included pictures.

The socket we have is 3 5/8" long. 5 holes. The inside opening is about an 1", the outside opening is about an 1 1/4"

I need two of the plastic socket that attaches the drawer roller rail to the inside wall of the kitchen cabinet. This part allows the pull drawer to be anchored and slide open whilst nested in the cabinet frame.