Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Need the inside we're the track fits to be 1". Doesn't seem to be available at local hardware or big box stores.

On bracket it has part number G6600 on one side and either the letter B or the number 8 inside a circle.

Hello,My name is Kevin, in Michigan.. I'm trying to identify and replace the plastic brackets that have broken and no longer support the side rails for the drawers in kitchen cabinets.I don't see a manufacturer name anywhere on the cabinets. The only part numbers I have are on the rails themselves a ... (cont.)

Need a left and right drawer socket for kitchen drawer.

Trying to identify this drawer bracket thanks Dave.

I was told by a reputable hardware store that my part # was 32-012. However when I measured it and compared the number the actual measurements were off from this part number's measurements. Can you help me?Yancey

Can you help me find the correct hardware? Older kitchen cabinets Looks like a chunky letter L. 2" x 2 1/4 Longer side is for slide. 1 1/4 wide.

Undermount kitchen drawer rail back support brike off. Can you help identify brand and sell me parts? Looks like plastic support fits into hole on steel back support? Thanks. Tom.

I don't have the cabinet brand but the metal slide is stamped unigrass 6600. I don't need the slides, just the plastic end the slide fits into. I need both left and right

I need the slide tongue or a replacement back bracket for this 22" Center slide rear mounting slide.

kitchen cabinet sliding shelf rear socket. Number stamped in side socket is 471037

This part is the plastic piece for the drawer track on the left side. It keeps the drawer tract from falling in the back. There are no item or part numbers on it. Help.

Cabinets are Merilllat , about 30 years old. We need this part for 2 different cabinets. Do you carry this?

Here is a picture of what the sockets look like. I could not find any make or model information on the hardware.

I'm having a hard time finding this particular boot because I'm sure its not available anymore. I writing you to see if you still have these types of drawer glide boots in your inventory,if not, please advised me on a suitable substitute I can order....Thanks for any reply on your part ...Michael ... (cont.)

I need a rear guide to fit a 1 inch metal guide. You will see one is broken on the right side. I need 3 sets of rear guides

These Merilatt cabinets were installed in 1994 and the plastic clip parts have not held up, as you can see. I would, however, like to replace just the broken clips for five drawers and five sliding shelves, if that is possible. I have photos on my phone. Is there a number or email where I could s ... (cont.)

Kitchen drawer part

Looking for 2 right and 2 left rear brackets that hold drawer glides in place. Kitchen cabinets were made by Merrilat

Hello, The picture shows the left version of a bracket that holds a rail that guides my kitchen drawer. It is attached to the back panel of the drawer. The right version is broken and I need to replace. I would like to order a few pairs that match the original. If this is not possible, I would con ... (cont.)