Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Only marking is "right" or "left". Approx 1.625" long Approx 1.25" wide Part is plastic. Holds the metal slide.

The mounting socket is a single "plug" type as shown in the picture. The bottom edge of the socket broke off and the end of the inserted slide will now not stay in the socket. Needs to be replaced. Don't know who the cabinet manufacturer is or the part number of the socket.I found out that the c ... (cont.)

Hello,I have attached two pictures of the part. I am hoping to not need to take the drawer apart until I have the replacement part to install. :) The piece that is broken is the one that attaches to the metal track.Thanks so much!Karen

This brcket shows that you no longer carrier it my home is 28 years old what can i replace it with

I've been trying to find these plastic pieces for my kitchen cabinet drawers for years and I've never found anything close in any of the local hardware stores. The rail that's attached inside the cabinet is 23" long. The rail is screwed into the cabinet on the front end and the back end is a peg typ ... (cont.)

Looking for replacements

I need replacement pairs of Heartland cabinet drawer slide supports. These attach in the back of the cabinet at the right and left sides of each drawer. They are about 2 3/16" long and the opening for the drawer slide roller is about 15/16." I need several pairs as the plastic at the bottom of th ... (cont.)

I need this back support for the right side. Do you make this?

In top left corner is circle with a D in it. Top right is G 6600. I found a post with Swisco as the manufacturer. Can you buy these bracket or is there a replacement bracket

To whom it may concern,See attached photos of the kitchen drawer track backplate for reference. Would you have this part in stock? FYI. The cabinets were installed in late 90's. Thanks for your help.Sincerely,Ron

Trying to find a replacement for my kitchen drawer glides

I need a pair of these. My wife keeps storing her anvils in our kitchen drawers. I change one of these every six months on a variety of drawers in her kitchen. My stock of these parts are running low.

Hass cabinets Rear draw slide bracket

I am trying to locate a guide to replace a few broken one. I have been unable to find anything equivalent to these at part stores or online. Any help would be greatly appreciated

Looking for replacements

My drawers are falling forward as these plastic sockets break from age. Are they still made?

This is the rear bracket that holds a drawer guide track in a kitchen base cabinet. The rear mounting surface is 1 1/4" x 2 1/8. Projection from the rear of the mounting surface is 2 1/4" The height of the channel is approximately 15/16"; I'm measuring to where I think the edge of the broken piece i ... (cont.)

this is a dreawer slide holder that fits at the rear of drawer. ther is a holder for the right and left side. it snaps in a metal holder. this is the right side pictured here. I have not been able to find anything like it. any help would be apreciated.Thank you, Dick

I need 2 kitchen drawer sockets for this drawer. The cabinet was made Scheirich and the drawer slide is marked with "CC" in a square and FANO-ITALY. Thanks.

I need replacement rear drawer socket s and hardware. The model numbers came off the drawer slides