Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

My apologies, I couldn't find a marking nor part number. I sent a front, side, and drawer side bracket.

These plastic drawer brackets are used in Kitchen Kompact cabinetsNeed price/availability on qty of 100Thank youMike

Looking to order 6 of these brackets, 3 left and 3 right. Do you have them in stock if so how can I order them. Thanks

This is a picture of the broken part still attached to the cabinet. a corner is broken off and the slider bar falls out. i need a replacement for this do you have it. Thank you in advance for your help.

For a kitchen drawer.

One inch wide opening.

On set of kitchen cabinets approx. 40 years old

rear socket for a side mounted pull-out shelf - 40+ year old cabinet

can you help me find this bracket

I am looking to purchase this item in the pictures for the back of my bathroom drawer.

Looking for replacement parts for our kitchen cabinets...

This is the left side piece for my rails it has the number 6 on it. The cabinet was purchased in 2005 at Menards.

looking for these drawer slide rear supports.there are no markings on them and not sure of the cabinet manufacturer.steve

Kitchen cabinet brackets for sliding shelves. House built 1991

The drawers slides were factory installed by Merillat the cabinet manufacturer. I need to move the drawer up higher in the cabinet. I can not get the slide to release from the socket nor can I unscrew the socket from the back wall of the cabinet. I removed one slide by bending it and finally pulling ... (cont.)

Looking for mountinftg bracket for metillat cabinets , house built 1988, drawer ,out can only mount on side since the cabinet opens 2 ways so you can't mount it to rear. Looking for side bracket mount for metillat cabinets, can't be a rear mount as cupboadsoprn 2 ways,

I have not been able to locate a back plate with this shape. This back plate has a notch in the front that acts as a stop for the glide. The rear of the plate is 2 1/4" tall. From the back to the front of the plate, the measurement is 2 1/4". The glide opening is 1 inch high and has a slig ... (cont.)

This is for my kitchen cabinet bottom drawer left side.Do you have anything that might work for me? inside the part there is a number it is:471037

I'm trying to find replacement brackets for my cabinets. The are about 1 1/4 wide where the rail connects and about 2 1/2 long. I've attached a few photos. Let me know if you have anything like this. Thanks Tom

This part attaches to a metal bracket mounted on the back wall of the opening. It snaps into the metal bracket. Need just one to replace this broken piece. If you don't carry this can you supply me with the manufacturer or a distributor? Thanks, Ron