Viewing all customer Discussions for:

90-279 Truth EntryGard Keeper, 2-1/16"

The Color of the latch is brown. Both sets of mounting holes that accept screws are 2 1/16 inches wide. The depth to the latch face on the piece with the lever is 7/16 of an inch. The mounting holes on the small piece Or 2 1/16 of an inch wide and 5/32 of an inch deep I would like to get three of th ... (cont.)

1. Window Lock - Entry guard, Truth, U.S pat 268.643 2. Tilt latch P54, P55

Lock number is 45226. Latch is 1/4" thick.

I'm purchasing 90-286 lock and I need a lock keeper that goes with that. Thanks

Hi, I ordered some truth window lock keepers from you guys but they were too narrow- the older version that I have is ~3/8" wide vs the newer version you sent me which is 1/4" wide. Would you guys still carry the wider version? Thanks.

Please help identify the picture of the sweep latch. The customer has painted it almond, it was originally white. The hole pattern is 1 13/16" which is way smaller than all that I have seen, 2 1/16 or 2 1/4". The customer needs 8 sets. There are no markings other than Pat. Pend. Thanks for help ... (cont.)

I need the locking mechanism and side latches (both pictures above) for Ellison validator series 200 windows. Could you please point me to the appropriate parts? Thanks, Rob

Seems bent and the holes look stripped

What is the keeper that is compatible with True window lock (90-077C)?

Looking for a few of these.

Looking for replacements for truth entrygard lock and keeper in white.

I am looking for a replacement sash lock for an atrium window. it looks like you have one in stock that looks similar, Can you tell me if they are the same, Thank You

I found a replacement for a vent latch (26-122) because it had patent #s on it & a google search led me to your site. The lock and keeper do not have any markings at all. Any help would be greatly appreciated!

Hello-I've been trying to locate the "receiving" part of my window latch, as shown in the pictures. The part is a 1/4" thick. The part I photoed is broken. I need 2 of these if you have or can locate them. Let me know if you have any questions. Thanks Chris

MW Manufacture Unity Cellular Double hung window installed new in 2004 The base of the catch has a bevel not squared off Thanks

(1) First two pictures: It's tilt window lock KEEPER BAR 29 inches long. Do you have this part or closest match?(2) 3rd and 4th Pictures : Block and tackle channel balance : Stamped/engraved 2500 BSI LB. In this one the spring holder is cracked!Do you have this whole part or closest match ?The block ... (cont.)

Hello, I am looking to replace my yellowed plastic window latches with white metal latches. The latch mounting holes measure 1 7/8 apart and the other side measure 2 1/16. 90-286 and 90-279 seem to fit. Are there any other measurements to consider?

Truth Window Lock / Entry Gard is wrong size (too thick) need 90-161 with narrow keeper and 2 1/16 spacing. I already ordered and tried 90-077C and 90-279 and they were too thick so I think I need the 90-161

MW window latch is UV damaged and cracked. Mounts on an angle instead of flat. Would prefer a metal replacement with bulk pricing to replace all latches in my home.

Hi - I'm trying to replace the metallic keeper portion of a vinyl sliding window lock. I'm not sure how to measure the width, but it appears to be 2 1/16" from center hole to center hole. Is it possible to match what I have, which allows for a margin of error in case the existing screw holes aren't ... (cont.)