Viewing all customer Discussions for:

23-455 60" Bifold Track, 4 Door (7/16" pin)

Need Hardware as shown in the pics for the door

Hi All, Got a by-fold door at one of my customers, most of the parts are malfunction. Have you got an agent here in Melbourne Victoria Australia? The top roller is missing not sure how that looks... Thank you for your help. Best regards Viktor

Need to find a new track for my doors. The pin in the corner is 7/16 pin and the roller that it slides on is about 5/8 inches. It says johnson on some of the parts and is a low profile track.

Is this track 1' wide I couldn't find the measurement anywhere

What country is this track mad ein?

Need upper track for folding door in garage. Damaged it when I grabbed door as I fell off my ladder. 60" long 7/8 " width actual opening 5/8". Need mounts at each end door fits in. My description probably not up to par, doors have been in garage for years & local hardware or Lowe's don't have t ... (cont.)

Hi My laundry closet has 4 panel bifold doors. The upper track needs replacing. The closet opening is 60" side to side. I measured the width (thickness) of the existing track and it is about 22.5 mm and accepts glide pins that are 7/16" ( shown in picture ). Please advise me which part would I ne ... (cont.)

Hello,How wide is the track? I am looking to replace a 5/8 inch track that got bent and will not work to hold tight the pivot bracket in the track (i.e the top pivot bracket will not tighten to hold the bi-fold door). I would much rather just replace the bent track then to have to replace all the ha ... (cont.)

My existing track is bent. I purchased a National hardware assembly kit thinking I could just use the track portion of the kit. In reality I would have to replace all hardware if I am forced to use this track. Is my existing track design obsolete replaced by a standard one design fits all? What ... (cont.)

I would like to replace both tracks and upper and lower brackets on my bi-folds. I have four panels for my 5 ft. Opening. The doors are very heavy as they are 6-panel oak. I will attempt to email a picture.

I'm trying to install 60" mirrored bifolds that weigh 46lbs per side. Do you have a track for that. They are series 1 Daiek Doors if that helps.

Is this track made out of aluminum or steel or stainless steel? Or if none of these what is this made out of?

This track has rusted out. It is 60" as there are two bifolds.

I need to replace a track for a very heavy 72" bi-fold closet door. I believe the track that the installer used, was not meant for a solid wood door and became bent. It would no longer hold onto the round head. I was looking at: 72" Bifold Track, 4 Door (7/16" pin) Product Code: 23-456 which loo ... (cont.)