Viewing all customer Discussions for:

90-072 Sweep Lock, 2-1/4"

Dimensions match your product 90-072, but looks more like 90-009 or 90-005. Hope these photos help you determine what product I need.

The windows are from "Champion Window". This company told me that the windows are of industrial grade (sold to a real-estate developer) and about 20 years old. The company cannot provide the parts. The 3 type of parts I need are shown in the attached photo. For a preliminary test I need: (1) Left & ... (cont.)

Looking to replace these vertical sliding window latches in my circa 1981 condo. Only marking is Allen-Stevens Corp. Handle screw holes are 4 1/4" apart and the Handle width is 15/16".

No other information found on window. This is a plastic sweeper in my vinyl coated aluminum frame windows. I have one that has broken. Looking for replacements and how to remove old one and install new one.

Hi, what's this piece of my window called. It this white latch on the bottom sash of my double hung window. It just wedges into the bottom on the top sash, so not sure if it's a lock or what part it is for replacement on another similar window. Thanks.

I need two Silverline 2900 SH sash locks for a single hung window manufactured in 2016. They are Sandstone finish.

I need a window lock similar to the 90-005 but with a 5/8" throw. Does anything like this exist? All dimensions for the 90-005 work for me with the exception of the throw. Needs to be 5/8". Thanks

These photos are of the hinges and latches off of a glass block window vent. I can't find them locally and hopefully you have them. The photos show good ones on another window in my house. I will need 4 hinges and three latches.

I ordered the 90-005 replacement locks and they fit perfectly but need longer lock to reach into the area between sashes. Do you have these?

I need a Viking replacement latch. Thanks, Alecia

Greetings I need 6 of these . Do you know if you carry ??My name is Stanley C

I'm looking for replacement window latches. Color is brown. Screws are on 2 1/4 centers I believe. Marking on the bottom says 'ActiveCo 718 522 0361', and there's a 9 on it. Material is some sort of cheap metal with brown enamel on it.

The receptacle side of the lock as pictured in the photo with the opening to receive the latch is broken (photo is of intact lock receptacle). Other photos of the latch show latch with broken receptacle thus unable to lock window.

Hi there, thank you for your help identifying the correct replacement part. The lock is curved on one side and where the locking mechanism engages inside the window is broken clean off.

I need a replacement for this latch for a sliding window. The window slides to the left. Can you help me?

28" wide by 58" tall sliding window Installation about 2006 Back of latch 10R-2

This is the lock on my IWC Slider Window (left to right) the mounting holes measure 2-1/4" apart. The house was built in 2004 with these windows.Larry

I am looking for the plate below. Can you help? Thank You Roger Shop Foreman

These latches measure as follows: Length = 2 3/4" Width = 3/8" Height = 3/4" Tongue in lock position = 1/2" Holes about 2 5/16 on center.

I'm trying to replace a window Lock. I specifically need the back piece that slides in that locks the window.