Viewing all customer Discussions for:

81-162 Roller Assembly, International

Hi, I would like to replace the rollers on a sliding glass door. Can you idenitfy and provide the correct part? Thank you, Robert

DEL MAR ENGINEERING LONG BEACH CA REST IS OBSCURED BY RUST wheel diameter is 1.5"

need help . no identifying markings/NUMBERS/NAMES. 1" 1/2 O.D. WHEEL. 3/4 WIDTH AT WHEEL, 2 1/4 LONG, 1 INCH 3/16

I am looking for a replacement roller for my roller shown in the picture. Dimensions are shown on my picture. Thank you.

The picture is of an aluminum sliding glass door roller. The wheel is 1 1/2 inches in diameter. It is 3/4 inches across to the dimple. It is 2 3/8 inches long in length before the K-tab or t-tab at the end which is an additional 3/4 of an inch.

I need 1 or 2 rollers for a sliding exterior door made by American Tempering Inc. Ansi z97-1-1972 187u. The part was made by del Mar Engineering patent 3670557 The wheel diameter is 1 1/4 "

I think I need a pair of your Part # 81-162, because it looks very similar, has the right dimensions, and it has a 1-1/2" plastic wheel.

International door

Hello, Can you please help us identify what type of roller wheels these are? We need a few replacements. The wheel is metal.

Are u still in business? Looking for four roller replacement for Herculite K sliding doors. Thanks.

Didn't find any identifying info whatsoever on my door or roller part. I'm thinking part # 81-162 "roller assembly, international." What do you think, likely a match? Clay

Nylon 1-1/2" roller. SYRACUSE is stamped into the side of the roller. DelMarEng, Long Beach, CA stamped on side of housing. Single wheel, two rollers on each door. 11/16" wide. 2 doors, need 4 rollers.

Trying to find the best replacement roller for an old aluminum door. According to an older post on your site the part I have is a discontinued part. It is labeled with Del Mar Eng, PAT 3.670.357. I have seen quite a few recommendations for a replacement for this item, but I'm still not sure which on ... (cont.)

Hello- looking to find a replacement for (10) roller assemblies for (5) of our sliding glass doors. They are from the late 70's so I know Del Mar discontinued the T shape. Below are photos of the old one. I have found T shapes by slide-co that fit perfectly but they are missing the side screw hole ... (cont.)

On a 1970s , large glass slider. We need 4., plus weather strip, which I will send separately. Thank you, Wendi CWe included a photo of the only markings. Let me know if you need anything else.

Wheel O.D.: 1-1/2" Housing Length: 2-1/8" Housing Height: 1-3/8" Housing Width: 9/16" Housing Width with Dimples: 3/4" Housing with Tab: 2-13/16"

Hello I'm looking for roller, it's for a glass door, I need 2 pieces Can you help me please Best regards

I have 4 doors that need two each of these

I have 3 sliding glass doors that need the rollers replaced. The doors are aluminum and I believe to be original to the home which was built in 1970. The only markings on the roller says DEL MAR ENG. LONG BEACH CAL. PAT. PEND.

I have looked at both part numbers: Product Code: 81-148 - Roller Assembly, 1-1/8" Steel Ball Bearing, Adjustable Product Code: 81-162 - Roller Assembly, International The only differences I can see is the size and material of the wheels. Looking at the pictures the wheel size of my part looks c ... (cont.)